LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Bolts for Front Skid
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=38250		 Page 1 of 1
Author:  lionseye640 [ Mon Dec 15, 2008 12:05 pm ]
Post subject:  Bolts for Front Skid
I'm picking up a front skid, and need to buy the mounting hardware. What do I need to buy & can I get it somewhere other than a dealership?
Author:  rangerd77 [ Mon Dec 15, 2008 12:14 pm ]
Post subject: 
you can get the bolts at any hardware store i do believe, but not sure what size they are, but ill look for ya
Author:  jeepkj02 [ Mon Dec 15, 2008 12:15 pm ]
Post subject: 
I know the head is 15mm (at least mine is, I've heard others people have different sizes), not sure of the thread size.
Author:  tulsa [ Mon Dec 15, 2008 12:31 pm ]
Post subject: 
Don't you need nutzerts with that?
Author:  tommudd [ Mon Dec 15, 2008 12:43 pm ]
Post subject: 
tulsa wrote:
Don't you need nutzerts with that?


front bolts on , nuts already up in the frame, not sure an the rear as I just drilled and bolted mine on, much stronger :wink:
Author:  jsc7002 [ Mon Dec 15, 2008 3:23 pm ]
Post subject: 
M10 with 1.5 pitch I THINK but its been a while since I replaced those bolts, the head does take a 15mm socket and you torque it to 45ft/lbs.
Author:  rangerd77 [ Mon Dec 15, 2008 4:23 pm ]
Post subject: 
hey Joey, you are right!

i just looked it up on my .pdf and thats what it said M10, 1.5 pitch
Author:  jeepskate [ Mon Dec 15, 2008 9:00 pm ]
Post subject: 
You'll probably want washers too (I think they're attached to the factory bolts). Make sure you get the right grade of bolts. Should be marked 10.9 on the head. And the length I think is 30mm.

And don't get the ones that are only half threaded. You want fully threaded bolts like this:
Image
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/