| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Disassembly UJoin from rear propeller shaft http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=38328 |
Page 1 of 1 |
| Author: | radame [ Wed Dec 17, 2008 5:52 pm ] |
| Post subject: | Disassembly UJoin from rear propeller shaft |
Does any one knows how to remove this?? I have the 03 manual but mine is 05 and pics from rear part are different, (UJoint) between shaft and rear diff. The manual says "Remove U-joint strap bolts at the pinion shaft yoke." but there are no "straps" Thanks in advance 
|
|
| Author: | tommudd [ Wed Dec 17, 2008 6:11 pm ] |
| Post subject: | |
mine has bolts did they change the 05s ? Does it have like the front diff, flanged with small bolts ( 8mm I think if I remember right) all the way around or what? picture or better description, guess I never paid that close attention to the newer ones |
|
| Author: | Jeepjeepster [ Wed Dec 17, 2008 7:07 pm ] |
| Post subject: | |
When I took my rear drive shaft off it just had 4 bolts that I took out and that was that. It just bolts up to that flange on the pinion. 
You can see one of the bolts in this pic: 
I would use lock-tite when you put the bolts back in. I used blue myself.. |
|
| Author: | 05infernoCRDL [ Wed Dec 17, 2008 9:23 pm ] |
| Post subject: | |
info on removin u-joints in 05 http://lostjeeps.com/forum/phpBB3/viewtop ... 723#398723 it is on the CRD part of the site |
|
| Author: | radame [ Thu Dec 18, 2008 11:11 am ] |
| Post subject: | |
Jeepjeepster wrote: When I took my rear drive shaft off it just had 4 bolts that I took out and that was that.
It just bolts up to that flange on the pinion. You can see one of the bolts in this pic: I would use lock-tite when you put the bolts back in. I used blue myself.. OK, I didn't say before, but I need to change the cross, that's why I asked this, I don't want to remove the shaft from the diff. Yes, you are rigth with the 2nd picture, but how can I remove the cross from the complete assy.?? In the 03 manual indicate to remove the strap to remove the shaft from the yoke and let the 2 bearing caps free, but in 05 there is no strap, so the 4 bearings are assemblied. I don't want to figure out by myself, untill somebody that already did this, can confirm the rigth way to do this |
|
| Author: | radame [ Thu Dec 18, 2008 11:14 am ] |
| Post subject: | |
05infernoCRDL wrote: info on removin u-joints in 05
http://lostjeeps.com/forum/phpBB3/viewtop ... 723#398723 it is on the CRD part of the site I see, so is quite similar but you need to press the bearing caps from both sides and not just 1, I will try this I will let you know any problem on this (I hope not to have any) Thanks to all for your comments!!! |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|