| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Can you loose a spring without the bumpstops? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=4081 |
Page 1 of 1 |
| Author: | LibertyCRD [ Fri Dec 09, 2005 9:06 pm ] |
| Post subject: | Can you loose a spring without the bumpstops? |
Got a few more pics on my cardomain page now: http://www.cardomain.com/ride/2164878 One thing I'm noticing about this lift that I didn't think of when I installed it is without the extra bumpstops they recommend it actually flexes a lot more than stock. I just hope I don't ever break anything or let the spring pop out doing this. What do you guys think? Nothing major here...just some basic wheeling... |
|
| Author: | DaveKJ02 [ Fri Dec 09, 2005 9:27 pm ] |
| Post subject: | |
I've seen a video floating around here of someones coil flopping out when fully dropped. |
|
| Author: | Eddo [ Fri Dec 09, 2005 10:01 pm ] |
| Post subject: | |
Not sure with the Daystar kit you have. Alot depends on what lenght shocks you have. If they are about the same lenght as the stock ones I would not worry about it. If they are as long as the RSX 17004 (~25" extended) then I'm not sure. Get it to full droop (tire off the ground) and give a tug on the spring and see if it looks easy to pop out. I have OME springs in the rear with the RSX17004. At full extension the spring is a little loose, but not even close to poping out. |
|
| Author: | Kugellager [ Fri Dec 09, 2005 10:20 pm ] |
| Post subject: | |
Eddo wrote: I have OME springs in the rear with the RSX17004. At full extension the spring is a little loose, but not even close to poping out. I would have to say though that jacking it up until full extension is achieved is not the same as it fully extending in the trail. I would still put the bump stop on if you have it.
John ];') |
|
| Author: | LibertyCRD [ Sun Dec 11, 2005 10:37 pm ] |
| Post subject: | |
OK, will the bump stops that they sell at www.boulderbars.com for the Skyjacker springs work with my Daystar spacer lift?? |
|
| Author: | lilmatty [ Sun Dec 11, 2005 11:15 pm ] |
| Post subject: | |
LibertyCRD wrote: OK, will the bump stops that they sell at www.boulderbars.com for the Skyjacker springs work with my Daystar spacer lift??
Call and ask. They won't bite. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|