| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Just 1" coil spacers front and back - do they exist? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=4230 |
Page 1 of 1 |
| Author: | Guest [ Fri Dec 16, 2005 3:15 pm ] |
| Post subject: | Just 1" coil spacers front and back - do they exist? |
I've searched the heck out of this board and found hundreds of great posts on this subject. I've seen 0.75" front spacers, 2-2.5" front and back spacers, spring lifts, ect. Is there just a simple 1" coil spacer for front and back on my 2005 CRD that I can use to get buy for a year or two until I figure out my driving and off road habbits better? 
If not, are there any low lift options? |
|
| Author: | the1jferg [ Fri Dec 16, 2005 3:58 pm ] |
| Post subject: | lift |
No. they don't exist. the .75 will raise you an 1 1/2" (did it). Levels it out real good. The best you can hope for is the rear shims from all J and the rusty's 1/2" front shims. https://rustysoffroad.com/Merchant2/mer ... sus_kj_par http://www.boulderbars.com/ No pics...must call You should forget this option unless its a pre-low and just go with the 2.5" |
|
| Author: | Guest [ Sat Dec 17, 2005 12:07 am ] |
| Post subject: | 2.5" spacer lift on a pre-low? |
Rather than start a new thread... What happens if you spacer lift a pre-lowered '02 (mine was built in March '02...how do I tell if it's a pre-lowered KJ?) 2.5"? is that effectively a 3.5" lift compared to all other KJ's, and you get the issues with the front CV shafts? |
|
| Author: | Jeepjeepster [ Sat Dec 17, 2005 12:29 pm ] |
| Post subject: | |
If you dont change teh springs and put in a 2.5in spacer, you will have another 2.5in of lift and would be around an 1in higher than a lowered libby. |
|
| Author: | ManicMechanicJoe [ Sat Dec 17, 2005 2:28 pm ] |
| Post subject: | |
I have a 2.5 inch Rusty's spacer lift on the way (yeah i know but it's to get by untill i can afford the Frankenlift) and a prelowered (august '01 build date) Liberty I will let you know what happens and how high I get with the kit. |
|
| Author: | Guest [ Sun Dec 18, 2005 2:53 am ] |
| Post subject: | |
thanks manic, better your CV shafts than mine:P |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|