| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Liberty Lift FAQ / please read before asking questions http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=44037 |
Page 3 of 3 |
| Author: | Science and Energy [ Wed May 24, 2017 11:36 pm ] |
| Post subject: | Re: Liberty Lift FAQ / please read before asking questions |
I don't see this question/answer: Which rear shocks to use for a Liberty CRD with 4 inches of lift? Any recommendations? |
|
| Author: | tommudd [ Thu May 25, 2017 8:42 am ] |
| Post subject: | Re: Liberty Lift FAQ / please read before asking questions |
Science and Energy wrote: I don't see this question/answer: Which rear shocks to use for a Liberty CRD with 4 inches of lift? Any recommendations? jeepinbyal lists the shocks which fit the 2.5-4 inch lifts etc |
|
| Author: | psmitty2 [ Thu Dec 28, 2017 1:49 pm ] |
| Post subject: | Re: Liberty Lift FAQ / please read before asking questions |
I am not a gearhead here, but I have a good tech to work on my 05 CRD. Three years ago, I put an OME 2.5" lift and put on 245/75/R16 tires. No rubbing, hammered the joint. This year, my wheel hubs needed replacing and my front tires were badly worn on the inside. I put on my stock 225/75/R16 snow tires. My question is: is that tire wear the result of bad camber from the shorter upper control arms? Would JBA UCA's allow a "stock" alignment and solve the problem? Thanks! 2.5" OME, ARB front bumper, GDE, Webasto, 001 thermostat |
|
| Author: | flash7210 [ Thu Dec 28, 2017 4:47 pm ] |
| Post subject: | Re: Liberty Lift FAQ / please read before asking questions |
You probably just need an alignment. Rotating your tires every 3-4 months wouldn’t hurt either. |
|
| Author: | mercdude [ Tue Jun 01, 2021 5:16 pm ] |
| Post subject: | Re: Liberty Lift FAQ / please read before asking questions |
An update: not sure if ARB/OME changed their production from when these numbers were originally posted a few years back but here is the information straight from ARB on current (2021) OME products for the KJ: Front 0. Stock spring - 320#/in 1. Light spring - 375#/in 385mm height 2. Medium spring - 375#/in 392mm height 3. Heavy spring - 400#/in 394mm height, thicker coils Rear 0. stock spring - 150#/in 1. light spring - 170#/in, 340mm height 2. Medium spring - 200#/in, 340mm height, thicker coils |
|
| Page 3 of 3 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|