| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Aftermarket Fender Flares http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=53796 |
Page 1 of 1 |
| Author: | KammerJammer [ Fri Jun 25, 2010 4:30 pm ] |
| Post subject: | Aftermarket Fender Flares |
Hey I see all of these pictures with different fender flares with the bolts on them. Where can I get them? |
|
| Author: | bugnout [ Fri Jun 25, 2010 4:52 pm ] |
| Post subject: | Re: Aftermarket Fender Flares |
There are three types of factory flares, Limited (painted) Sport (gray plastic) and renegade (fake bolt pockets). You can order them from the dealer. There are no aftermarket flares available yet. |
|
| Author: | KammerJammer [ Sat Jun 26, 2010 12:03 pm ] |
| Post subject: | Re: Aftermarket Fender Flares |
Awesome! And they are pretty interchangeable then right? Like can I put the fake bolt pocket ones on my limited |
|
| Author: | mag03kj [ Sat Jun 26, 2010 12:45 pm ] |
| Post subject: | Re: Aftermarket Fender Flares |
Yes they are! You just have to find them! I got a 03 Freedom Edition with the Bolt-On look....Same a Renny tho! |
|
| Author: | TallNorton [ Thu Jul 01, 2010 1:47 pm ] |
| Post subject: | Re: Aftermarket Fender Flares |
I've been doing a search.....is there an existing thread that details how to remove the rear fenders? I'm chasing a wire that was installed for my rear hitch receiver and it appears to enter the floor behind the passenger side tail light and then go up behind the fender. The 4-pin connection isn't functioning properly and I want to check the connections where it ties into the main wiring. |
|
| Author: | bugnout [ Thu Jul 01, 2010 7:09 pm ] |
| Post subject: | Re: Aftermarket Fender Flares |
I don't think there is any wiring under the flairs, you will need to remove the interior plastic trim to get at the wiring. |
|
| Author: | TallNorton [ Thu Jul 01, 2010 7:16 pm ] |
| Post subject: | Re: Aftermarket Fender Flares |
bugnout wrote: I don't think there is any wiring under the flairs, you will need to remove the interior plastic trim to get at the wiring. It looks like you're absolutely correct. I did some more research after my post and found that I needed to remove the interior cargo area panel to access that wiring run that was disappearing into the floor pan from underneath. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|