LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Grave digging for KJ Parts
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=56515		 Page 1 of 1
Author:  JeepJeff [ Wed Oct 27, 2010 4:25 pm ]
Post subject:  Grave digging for KJ Parts
Well, I am both happy and sad to report that I have tried just about every junkyard in NJ and no one has a 02-07 KJ. I guess that means that they are all still on the road! I am looking for a rear hitch assembly for an '04 and no one has one or any KJ's for that matter. So it looks like I will be shopping for an after market part for something that should have come standard on my "new" used vehicle.

So... I am looking for a hitch to pull my rig out of the mud, or what-ever else I may get into, if needs be. I have been looking at the Rigid hitches and torn between a class IV (5000lbs) or a III (3500lbs). Thoughts? I am not going to be doing any major towing with this.

http://www.reese-hitches.com/products/C ... tch,RH-054
Author:  dgeist [ Wed Oct 27, 2010 4:58 pm ]
Post subject:  Re: Grave digging for KJ Parts
You mentioned the one use that may exceed the rating of a ClassIII, being pulled out of the mud. Although the IIIs and IVs are similar structurally, the IVs are usually made a little more rigidly such that a side load (like being yanked out of a ditch at an angle) is less likely to bend anything. The frame brackets typically extend farther up the length of the frame and that's what gives you a lot of the rigidity. Unless you're really just stuck on the looks of the ClassIII tubular, go ClassIV and have a little piece of mind. Whatever you do, stay with the 2" receiver.

Dan
Author:  JeepJeff [ Thu Oct 28, 2010 1:39 pm ]
Post subject:  Re: Grave digging for KJ Parts
Good Stuff! Just bought the bolts, washers, and nuts. Going to order the hitch tomorrow..
Metric hex bolts, Metric standard bolts, Steel grade 10.9, 12mm x 1.75 x 45mm
Going to go with the Class 4 with the 2 inch receiver.

http://www.reese-hitches.com/product...r_Hitch,RH-054/

I will post some pix once it is all on. :arrow:
Author:  yodejt02 [ Thu Oct 28, 2010 1:49 pm ]
Post subject:  Re: Grave digging for KJ Parts
Glad to see you are going with a reese that is NOT adjustable/ universal. :D
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/