I recently bought a powertrax locker off of a lost member and he said he has lost a tool that comes with the locker. He said its for spacing the Gap when the locker is installed. I've never heard of this in any of the write-ups I've read. Can anyone enlighten me on what this is/does? Thanks.

_________________
LOST KJ'S
Where are you going???
Current Jeep: 2004 Jeep Liberty
-Atlantic Blue
-Air Ride Rear Suspension ; OME/Rustys Lift ; Powertrax Locker ; Moog Lower Ball-Joints ; 245/70/16 Yokohama Geolander A/T-S's on MOABS ; Flowmaster 50 SUV
Lost #007082
http://www.cardomain.com/id/jeepjeepster

It's just a rectangular steel pin. About the size of a pencil. You use it to slide it in the pieces of the locker to see if they are spaced correctly after the install. call richmond gear and they'll send you one probably.

_________________

2005 Stone White KJ Limited CRD 4x4
Off-Road Pkg
Trac-Lok
Emu 790s/948s
Skyjacker H7088s rear/Bilsteins front
15x7 Black Rock Lobos/31x10.50 Firestones
GDE HOT Tune + TCM Tune
Euro TC
CB radio
Thrush Turbo muffler
AEM DryFlow filter

The correct gap is greater than .135 thousands and less than .170 , just measured the one that came with mine. Did he give you the booklet that came with the no slip?

He's shipping it today. Hes looked everywhere for that little tool but cant find it, yes he did just send a pm saying he found the orignal instructions and owners manual so thats good. He said he's going to call and try to get one, he's taking good care of me!

I was just wondering what its used for, thanks guys!

_________________
LOST KJ'S
Where are you going???
Current Jeep: 2004 Jeep Liberty
-Atlantic Blue
-Air Ride Rear Suspension ; OME/Rustys Lift ; Powertrax Locker ; Moog Lower Ball-Joints ; 245/70/16 Yokohama Geolander A/T-S's on MOABS ; Flowmaster 50 SUV
Lost #007082
http://www.cardomain.com/id/jeepjeepster