| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| PowerTrax locker? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=6424 |
Page 1 of 1 |
| Author: | Jeepjeepster [ Mon Mar 06, 2006 11:09 am ] |
| Post subject: | PowerTrax locker? |
I recently bought a powertrax locker off of a lost member and he said he has lost a tool that comes with the locker. He said its for spacing the Gap when the locker is installed. I've never heard of this in any of the write-ups I've read. Can anyone enlighten me on what this is/does? Thanks. |
|
| Author: | LibertyCRD [ Mon Mar 06, 2006 11:14 am ] |
| Post subject: | |
It's just a rectangular steel pin. About the size of a pencil. You use it to slide it in the pieces of the locker to see if they are spaced correctly after the install. call richmond gear and they'll send you one probably. |
|
| Author: | Neal [ Mon Mar 06, 2006 11:26 am ] |
| Post subject: | Gap Tool |
The correct gap is greater than .135 thousands and less than .170 , just measured the one that came with mine. Did he give you the booklet that came with the no slip? |
|
| Author: | Jeepjeepster [ Mon Mar 06, 2006 11:55 am ] |
| Post subject: | |
He's shipping it today. Hes looked everywhere for that little tool but cant find it, yes he did just send a pm saying he found the orignal instructions and owners manual so thats good. He said he's going to call and try to get one, he's taking good care of me! 
I was just wondering what its used for, thanks guys! |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|