| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Jeepin by Al lift http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=67016 |
Page 1 of 1 |
| Author: | dogfacejay [ Tue May 22, 2012 9:42 pm ] |
| Post subject: | Jeepin by Al lift |
Has anyone tried the Jeepinbyal.com lift? Seems like he has done his homework. It`s not cheap, but looks thorough. |
|
| Author: | tommudd [ Tue May 22, 2012 9:59 pm ] |
| Post subject: | Re: Jeepin by Al lift |
Several have JBAs lift all depends on what you want and how much you want to spend |
|
| Author: | sacax [ Wed May 23, 2012 3:14 am ] |
| Post subject: | Re: Jeepin by Al lift |
Hello! I have the 2.5"one... rides great! expensive as hell (i had to pay like 30% more on tax and VAT when importing) but i am very happy with it... still have to go off road with it and let you know... my guess is that it will suit my needs ( though needs are changing rapidly)... And a question for tommud if you can help... is it possible to put on top of the AAS mount a top plate? just thoughts of getting it a bit higher... Once it starts, you are lost (but I'm sure you know better than me...) Thanks! |
|
| Author: | Pippobug [ Wed May 23, 2012 3:32 am ] |
| Post subject: | Re: Jeepin by Al lift |
[quote="sacax"]Hello! And a question for tommud if you can help... is it possible to put on top of the AAS mount a top plate? just thoughts of getting it a bit higher... Once it starts, you are lost (but I'm sure you know better than me...) quote] Hi Sacax, yes you can add Top plates at the front. I have added 3/8 in Boiler ( see section on main board sales item or JBA sells then to) ones on OME 790 coils and I have a CRD 2.5 like yours. I have to fit JBA 4.5 arms to and I am sitting at 22 in now. My advise would be not to do it or fit thinner ones 1/4 in from Boiler, reason is it pushes the front far to up and causes serious problems with camber and allignment. I have had my lift on now over a year and still can't get the front end fully sorted out ( I also have changed ALL the front bushed top and lower arms). Fil. |
|
| Author: | sacax [ Wed May 23, 2012 3:45 am ] |
| Post subject: | Re: Jeepin by Al lift |
Thank you! I was thinking about the 1/4 ones actually... I dont want to put too much stress on it... the issue is that I am thousands of miles away from US and it is quite hard to get parts if needed... but i will get the top plates and some extra rear ISOs  ))I will have to clean the MAP sensor also (since I have seen everyone does it) the former owner did not do it'on my KJ so... It was my mom ))))Thank you! |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|