Has anyone tried the Jeepinbyal.com lift? Seems like he has done his homework. It`s not cheap, but looks thorough.

Several have JBAs lift
all depends on what you want and how much you want to spend

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited

Hello!

I have the 2.5"one... rides great! expensive as hell (i had to pay like 30% more on tax and VAT when importing) but i am very happy with it... still have to go off road with it and let you know... my guess is that it will suit my needs ( though needs are changing rapidly)...

And a question for tommud if you can help... is it possible to put on top of the AAS mount a top plate? just thoughts of getting it a bit higher... Once it starts, you are lost (but I'm sure you know better than me...)

Thanks!

_________________
2002 2.5 CRD Sport KJ (with some LTD options on it)
2.5" JBA lift
4.5 Gen JBA UCAs
Detroit Locker on rear
245/75R16 BFG MT KM2 on stock rims
FULL skids

[quote="sacax"]Hello!
And a question for tommud if you can help... is it possible to put on top of the AAS mount a top plate? just thoughts of getting it a bit higher... Once it starts, you are lost (but I'm sure you know better than me...)
quote]

Hi Sacax,
yes you can add Top plates at the front. I have added 3/8 in Boiler ( see section on main board sales item or JBA sells then to) ones on OME 790 coils and I have a CRD 2.5 like yours. I have to fit JBA 4.5 arms to and I am sitting at 22 in now. My advise would be not to do it or fit thinner ones 1/4 in from Boiler, reason is it pushes the front far to up and causes serious problems with camber and allignment. I have had my lift on now over a year and still can't get the front end fully sorted out ( I also have changed ALL the front bushed top and lower arms).

Fil.

_________________
CRD 2.5 2003

Snorkel
Curt Front Hitch+Warn M8000 & Cradel
Asfir Front, Gearbox,Transfer Skid + Mopar Tank Skid
BF Goodridge KM2 & General Grabbers AT 245/75R16
OME NS131&790 + NS132L&948, 3/8 Boiler Top Plate, JBA 4.5, 2 Top Rear Isolators

Thank you!

I was thinking about the 1/4 ones actually... I dont want to put too much stress on it... the issue is that I am thousands of miles away from US and it is quite hard to get parts if needed... but i will get the top plates and some extra rear ISOs ))
I will have to clean the MAP sensor also (since I have seen everyone does it) the former owner did not do it'on my KJ so... It was my mom ))))

Thank you!

_________________
2002 2.5 CRD Sport KJ (with some LTD options on it)
2.5" JBA lift
4.5 Gen JBA UCAs
Detroit Locker on rear
245/75R16 BFG MT KM2 on stock rims
FULL skids