I am a mechanical novice, so go easy on me. I am working on installing a RRO Rockfather 2 lift and A arms (I know, first mistake ). My buddy and I got everything off and we put the pre-assembled strut in. We put the strut fork on and it looks like the strut fork just goes way too low to ever bolt the bottom to the lower control arm. We tried loosening the control arm, but it didn't help. The only possible way it looks like it would fit is if we had a spring compressor. Also the strut seemed to be almost touching the CV boot, this looked concerning. I am wondering if I got the wrong parts or am missing some trick here.

_________________
2005 Black Jeep Liberty Sport 4WD- 6spd; Cobra 29 LTD BT CB Radio with 4' Firestik antenna;
Cragar Soft 8s with General Grabber AT2; 2.5in RRO suspension lift; ARB Bumper with KCs

Did you take upper control arm off at ball joint,sway bar end links so the lower control arm can drop .

_________________
2005 jeep liberty CRD GDE Full Torque Eco tune,Blue Samcos,Transgo shiftkit,Provent,V6 Airbox, Facet 40109 fuel pump ,Straight piped . OME lift 235/75/16 Hankook DynaPro ATM tires,weeks101 elbow kit FCV/EGR delete

Yep, had it all off.

_________________
2005 Black Jeep Liberty Sport 4WD- 6spd; Cobra 29 LTD BT CB Radio with 4' Firestik antenna;
Cragar Soft 8s with General Grabber AT2; 2.5in RRO suspension lift; ARB Bumper with KCs

Pics would be helpful if you can, basically what your saying is the shock and coil seem to long and you would need to compress it to get it to bolt?

_________________
2006 Liberty KJ
- 3.7 V6 - OME 927/948 - Bilstein shocks - Teraflex bumpstops
- 245/75/16 Hankook Dynapro ATM - 1.25" Spidertrax Wheel Spacers
- Boiler's Roof Rack - CRS Rock Rails - All J Cargo Tray
- Cobra 75WSXT - 4 LED Roof Lights - Bed Lined Bumpers/Fenders

Rachet straps
two of them , one of each leg of the clevis
hook near the bottom of the legs and pull them right in, yes it may look like it won't go but they will, never even have to loosen the LCAs
I'd send their UCAs back and get some good ones from JBA though

_________________
MUDD'S MOTORSPORT'S We do IFS lift installs ,
03 OVERLAND EDITION /Kilby-Skidrow-Mopar-4XGuard skids/ 2.5 inch TOTAL CONTROL JBA coilovers -JBA Arms/MOABS-31 FALKEN WILDPEAK AT3W / 4.10's etc, 04 Kilimanjaro Edition loaded, plus 05 KJ limited