I own a 2006 Jeep liberty limited 4x4 3.7
I just put all new brakes rotors all the way around. I also put new E-Brake Shoes on. Well for some reason the ebrake still doesnt hold at all and there is a metal on metal rubbing coming from the back passenger side. (Maybe front not 100% sure) I have tried to adust them from the rear and still the same. Anyone have any idea what else it could be and what the metal on metal is?

Did you replace the brake hardware when you changed the rotors? I rarely ever went to the trouble or expense of replacing the hardware when changing rotors, but when I replaced the rear rotors on my Liberty, one of the pins that goes through the backing plate, shoe and hold down clip broke the day after I replaced the parking brake shoes. I made an awful metal on metal racket..Twenty dollars later I was all good again...Also, make sure your parking brake shoes aren't adjusted to tight, and dragging....Your parking brake can be adjusted underneath the center console:
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?t=19141

_________________
Black '05 Renegade. Front suspension: Frankenlift, Moog HD LBJ's, Audiboy cut CV's
Rear suspension: OME 948's, 2 extra upper ISO's, Rancho RS 5000 shocks.
31X10.50X15 Duratrac's/ProComp 152's
ARB bumper, Mopar skids, JCR stage III's, Reese hitch with tractor lights, Champion shackle insert, "homebrew" on board air, 1000 watt inverter