LOST JEEPS :: View topic - CRD strut assembly on Gas Liberty Sport?

Hey, I need to replace my struts and springs, sitting very low in the front. Doing ball joints and all that as well under my aftermarket warranty. I don't want to lift it because my parking garage is low, and I routinely have several surfboards on the roof and that would be too close for me. Plus parking garages in Honolulu are low and I go in and out of them for work a lot.

My question is if the stock CRD strut assembly with a stiffer spring rate would fit on my gas jeep sport so they wont sag so quickly? I'd imagine the bolt pattern and all would be the same, just the spring rate would be higher right? might do a trim spacer on top of it for a little more clearance when i put on my 245/70/16 duratracks.

If anyone knows let me know! I know the ride will be stiffer but I'll take that over the lowered front end look! Aloha and mahalo for your help!

-2005 Jeep Liberty v6 gas sport, 4x4, 57k miles currently

Author:	7th Jeep [ Wed Jun 10, 2015 9:16 pm ]
Post subject:	CRD strut assembly on Gas Liberty Sport?
Hey, I need to replace my struts and springs, sitting very low in the front. Doing ball joints and all that as well under my aftermarket warranty. I don't want to lift it because my parking garage is low, and I routinely have several surfboards on the roof and that would be too close for me. Plus parking garages in Honolulu are low and I go in and out of them for work a lot. My question is if the stock CRD strut assembly with a stiffer spring rate would fit on my gas jeep sport so they wont sag so quickly? I'd imagine the bolt pattern and all would be the same, just the spring rate would be higher right? might do a trim spacer on top of it for a little more clearance when i put on my 245/70/16 duratracks. If anyone knows let me know! I know the ride will be stiffer but I'll take that over the lowered front end look! Aloha and mahalo for your help! -2005 Jeep Liberty v6 gas sport, 4x4, 57k miles currently

Author:	tommudd [ Thu Jun 11, 2015 5:07 pm ]
Post subject:	Re: CRD strut assembly on Gas Liberty Sport?
7th Jeep wrote: Hey, I need to replace my struts and springs, sitting very low in the front. Doing ball joints and all that as well under my aftermarket warranty. I don't want to lift it because my parking garage is low, and I routinely have several surfboards on the roof and that would be too close for me. Plus parking garages in Honolulu are low and I go in and out of them for work a lot. My question is if the stock CRD strut assembly with a stiffer spring rate would fit on my gas jeep sport so they wont sag so quickly? I'd imagine the bolt pattern and all would be the same, just the spring rate would be higher right? might do a trim spacer on top of it for a little more clearance when i put on my 245/70/16 duratracks. If anyone knows let me know! I know the ride will be stiffer but I'll take that over the lowered front end look! Aloha and mahalo for your help! -2005 Jeep Liberty v6 gas sport, 4x4, 57k miles currently Will bring you back to stock height of the gasser new plus possibly 1/2 inch or so

Author:	7th Jeep [ Fri Jun 12, 2015 7:16 pm ]
Post subject:	Re: CRD strut assembly on Gas Liberty Sport?
Awesome, thanks for confirming! I think i shall go this route, may not even need a trim spacer then! Have a good weekend!

LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/

CRD strut assembly on Gas Liberty Sport? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=82347	Page 1 of 1

Page 1 of 1	All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/