LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

10" Rigid Industries S2 Bar added to 4xGuard Front Bumper
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=82672		 Page 1 of 1
Author:  DarbyWalters [ Thu Jul 23, 2015 1:52 pm ]
Post subject:  10" Rigid Industries S2 Bar added to 4xGuard Front Bumper
Added a 10" LED S2 Driving Bar to the 4xGuard center bumper section...very bright...pretty flush mount

Next I am going to build my own ends for the center section that will have braces that pass thru the plastic bumper cover for support.


Image
Author:  Arkie [ Thu Jul 23, 2015 2:31 pm ]
Post subject:  Re: 10" Rigid Industries S2 Bar added to 4xGuard Front Bumpe
Looks good! Like it belongs there.

Bob
Author:  mass-hole [ Thu Jul 23, 2015 8:32 pm ]
Post subject:  Re: 10" Rigid Industries S2 Bar added to 4xGuard Front Bumpe
Link? I wanna put one on my arb
Author:  DarbyWalters [ Fri Jul 24, 2015 8:50 am ]
Post subject:  Re: 10" Rigid Industries S2 Bar added to 4xGuard Front Bumpe
mass-hole wrote:
Link? I wanna put one on my arb


You can get LED light bars on Ebay etc. Cree and Chinese Cheap ones. There is a company in Texas called Plashlights that
has a good selection. I was specifically looking for the S2 Driving Pattern...so I paid the price for Rigids.

Just know that installing most LEDs lights will screw up your radio with interference...RF signals. None of them seem to be shielded enuff
cancel out white noise.
Author:  riptricket [ Fri Jul 24, 2015 2:17 pm ]
Post subject:  Re: 10" Rigid Industries S2 Bar added to 4xGuard Front Bumpe
I have several of the cheap eBay ones. They are actually pretty good quality and come with a warranty.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/