I have a light bar switch I would like to mount and plan on and ARB locker at some point, so I was wondering where folks are mounting switches?

_________________
2006 CRD - GTB2056 turbo by Dieselguy86, Eco Trans Tune, Lift Pump, Week's, HDS Tstat, Racor Filter, ARP's, OME 790's+Top Plate, JBA 2.5", JBA UCA, Moab's+265/75R16, ARB Bull Bar, 4.10's, TrueTracs

Just below the steering column, on both the left and right sides, are plastic trim covers. Easy places to add switches.
And in the fuse box panel next to the drivers door you might find a empty relay socket. One of those pins is an easy path to ground.
You might even find a unused key-on +12v socket. Just be sure to use a fuse appropriate for the amp draw of of your light.

_________________
U.S. Army Retired

don't put it where i put one of mine, a few inches below my roof light button..

i've stabbed myself in the knee with it more times than i'd like to recall

reference:
Not here:

_________________
03 Renegade (Black)
177k miles 3.7L gas - 45RFE
Command Trac / 4.10s
Lift: ft. 790+ rr. JBA4+
The last of the TrailReady Front&Rear Bumpers and TR Rock Rails
Jarhead Offroad light covers
31x10.5R15 RedLetter Grabbers on Blackrock Dunes
L.O.S.T #KD098632

good call. I already had all the wiring, switch, everything because I initially wired it into my high beams. There are a ton of elk and deer around here and my wife was driving home in the dark so I wanted to get it on asap. Now I have some time to actually install the switch so its independent.



Oh yeah, I can see that. I smash my knee on the spot occasionally.

_________________
2006 CRD - GTB2056 turbo by Dieselguy86, Eco Trans Tune, Lift Pump, Week's, HDS Tstat, Racor Filter, ARP's, OME 790's+Top Plate, JBA 2.5", JBA UCA, Moab's+265/75R16, ARB Bull Bar, 4.10's, TrueTracs