LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

2004 jeep liberty limited 4x4 trailer light adapter Help!
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=86504
Page 1 of 1

Author:  akafireball [ Fri Apr 28, 2017 11:05 am ]
Post subject:  2004 jeep liberty limited 4x4 trailer light adapter Help!

Ok i tried searching on the forms here for a good while with no luck but i'm sure this is a real common prob on kj's
trailer lighs t connectors or ?
any way long story ,just killed my second trailer light t connector in abt 6 years lost 1 side of my running lights and blew the fuse replaced the fuse t connector is dead just like last one last abt 1 to 2 years ... this one was Curt mfg 1st one i think was Reece
whats the best option on these Kj's ? went to dodge the want $80 for an oem mopar kit in a bag w a pig tail to cut up tail harness to crimp and butt splice or solder in their adapter that can't be the best option...
id like something along the t connector style w out a bunch of wire cutting
i use dielectric grease tape and seal it all up so i know moisture is not the issue here
thanks fellow Liberty owners in advance
God Bless

Author:  WWDiesel [ Fri Apr 28, 2017 12:46 pm ]
Post subject:  Re: 2004 jeep liberty limited 4x4 trailer light adapter Help

Are you sure your trailer circuit is not pulling too many amps and overheating the "Tee" connector?
You may want to try going to LED bulbs on the trailer and see if that helps... :idea:
Seems to me you might be overloading the circuit somehow? :roll:

Author:  akafireball [ Sun May 14, 2017 6:52 pm ]
Post subject:  Re: 2004 jeep liberty limited 4x4 trailer light adapter Help

so im going to try this one
Tow Ready 118524 T-Connector Assembly 02-07 LIBERTY (KJ)
this time it draws 12v power off the battery and uses taillights as signal only ill report back if it dies prematurely...lol..

Author:  tommudd [ Mon May 15, 2017 2:42 pm ]
Post subject:  Re: 2004 jeep liberty limited 4x4 trailer light adapter Help

akafireball wrote:
Ok i tried searching on the forms here for a good while with no luck but i'm sure this is a real common prob on kj's
trailer lighs t connectors or ?
any way long story ,just killed my second trailer light t connector in abt 6 years lost 1 side of my running lights and blew the fuse replaced the fuse t connector is dead just like last one last abt 1 to 2 years ... this one was Curt mfg 1st one i think was Reece
whats the best option on these Kj's ? went to dodge the want $80 for an oem mopar kit in a bag w a pig tail to cut up tail harness to crimp and butt splice or solder in their adapter that can't be the best option...
id like something along the t connector style w out a bunch of wire cutting
i use dielectric grease tape and seal it all up so i know moisture is not the issue here
thanks fellow Liberty owners in advance
God Bless



etrailer, plug and play, been good for 13 years

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/