So I finally got a chance to remove my rocker panel since I knew there was some rust underneath it and I want to repair it as much as I could before it got worse. Anyways, I was too late. I was able to take the rocker panel off but I don't think I will be able to put them back on. The rust is so bad that there are hollow holes. Part of the metal is so bad that it just broke apart when I was trying to sand it down. Has anyone encountered this? What was your solution?
My plan is to probably keep the rockers off. I prefer to put them back on but like I said, I don't think it will be able to hold it.
As far as the rust, I was able to sand down as much as I could an I am next going to use rust converting metal primer, like this
https://www.amazon.com/gp/product/B001C ... UTF8&psc=1. And then paint over it.
Terry