What are ya'll running for pinch weld height after your lift? I'm currently at 17 3/4" in the front and 17 1/4" in the back. I'm going to raise the back another .500" and maybe go the full 1".

Am at 17 3/4 front and rear with 2 extra spring isolators on each side(3 total per side)
in rear. I purchased the 4 isolators from Mopar Parts for about $30. Running 245-75-16 tires. Quinn didn't want to supply them for free to level it out.

Wow, I'm only at 16" up front and 15" in rear from ground to bottom of the pinch weld. But then again, my KJ weighs 4,800 lbs.

_________________
Adam
KJ is SOLD for a JK Rubi Unlimited!
2003 Renegade.

http://www.cardomain.com/ride/3199258

JeepTales

I'll measure mine tomorrow and then we'll have 3 different lift styles to compare height with....

_________________
Had 2005 KJ Rocky Mnt. Edition (destroyed)
Had 2006 KJ Sport 4x4
Have 2007 JK 4-dr Sahara 4x4 (tow package so stock 4.10s!!)
AEV 3.5" RS Lift; Schrockworks FR bumper and Warn 9.5ti winch; Cobra 75 CB; Rigid 50" LED light bar; Adventure Trailers (AT Overland) JK Kitchen setup in the cargo area.
Southern L.O.S.T. # 236487

Well, I just measured mine here at work and I have 16 3/4" front and about 16 1/4" rear...there is a stock '02 (pre-lowered) that one of the guys here at work drives and I'll measure his monday (he's off today) and see how much a difference it is compared to the lifted ones....

_________________
Had 2005 KJ Rocky Mnt. Edition (destroyed)
Had 2006 KJ Sport 4x4
Have 2007 JK 4-dr Sahara 4x4 (tow package so stock 4.10s!!)
AEV 3.5" RS Lift; Schrockworks FR bumper and Warn 9.5ti winch; Cobra 75 CB; Rigid 50" LED light bar; Adventure Trailers (AT Overland) JK Kitchen setup in the cargo area.
Southern L.O.S.T. # 236487

Hey Mutt, I was wondering why I was staring at the sky. I'm 16 3/8 in the front and 16 1/2 in the back. Does that mean your keeping the KJ ?????

_________________
Frankenlift,Gibson Performance Exhaust
K&N drop-in filter

Yes, I'm keeping it, I'm over my raniting temper tantrum.

Yours seems to sit almost level, being a touch higher in the rear.....Hmmm.

Forgive my ignorance, but where is the pinch weld?

_________________
2002 Jeep KJ Sport 3.7L 4x4

245/75-16 Mastercraft Courser HSX, 16x7 Cragar, 2" OME MD Lift, ARB Bumper
AEM Brute Force Cold Air Intake, Flowmaster Super 44 Muffler

Currently working on: Full service on transmission & bed-lining ARB bumper

viewtopic.php?f=43&t=84650