LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
3" RRO Lift with JBA upper A arms - Trying to fit 235/85r16 http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=3&t=91687 |
Page 1 of 1 |
Author: | BrianUnderwood [ Wed Sep 23, 2020 12:46 pm ] |
Post subject: | 3" RRO Lift with JBA upper A arms - Trying to fit 235/85r16 |
As the title says I've got a 3" RRO lift with OME parts and JBA upper A arms, and I'm wanting to fit some 235/85r16 tires in there... I know I've gotta do some trimming and pinch weld bashing, but is there anything else I should do? And is there a reason why people put that plastic wheel well liner back in instead of using bedliner in it? Seems like you'd gain an extra 1/4"-1/2" by leaving the liner out and painting the wheel well... |
Author: | CATCRD [ Fri Oct 16, 2020 10:35 am ] |
Post subject: | Re: 3" RRO Lift with JBA upper A arms - Trying to fit 235/85 |
I never took the wheel well liners out. I cut next to the pinch weld, beat it flat and painted it, then used a heat gun to melt the liner flap over and seal it. I just think it looks better with the liners in. I had to trim the front of the liners and the bottom lip of the air dam out by the tires, and remove the washer fluid bottle. I installed a small generic one in front of the airbox, that reuses the factory pump and level switch. |
Author: | ATXKJ [ Thu Dec 10, 2020 6:20 pm ] |
Post subject: | Re: 3" RRO Lift with JBA upper A arms - Trying to fit 235/85 |
I had 2 different sets of 245/75/16's MTR's (from an 05 Rubicon) did not scrape Cooper manufactured At (forgot the version) did scrape I trimmed the plastic and hammered the pinch weld - no problems |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |