I recently bought a light bar from a guy on facebook. Found a manual online on how to wire it but it seems I am missing a few wires. The switch i have has a built in relay with 6 wires which I don’t know where any of them go. Any help? I’ve included a pic of the only two plugs/wires I have. This is a “hella” light bar.

https://imgur.com/a/yO6ZCEf

edit: the relay switch has a pink wire, an orange wire, a black wire, one thick white wire and one thin white wire, and a thick red wire.

Typical wiring diagram with switch and relay for aux. fog or driving lights.

_________________
Supporting Vendor and Moderator of LOST
05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount
98 Dodge Cummins 24 Valve

Sorry I really don’t have a clue what I’m doing with this electrical stuff. Is each colored line in that diagram which wire from the relay goes where?

If you want to use the factory light switch on a factory light bar you should download the service manual. Inside the manual are the wiring diagrams with color code to wire it up. Pretty easy to follow and do.

If you want to just light up the factory light bar with an after market on/off switch, follow what WW posted and wire it up to the battery using a fused and relay setup.

_________________
05 CRD; Rebuilt top end w/ARP studs, EGR delete, SEGR, 3.7L HD cooling fan, Samco hoses, in tank pump, JBA coil overs & control arms, KK clevis fork, 1/2" cradle drop, 1/4" motor mount lift, WJ rear upper trilink w/WW mount, WJ lower control arms, 4:10 gear, front/rear air lockers, ARB bumper, Rock Lizard sliders/roof rack, Mod T-stat