Hola everyone,

Anyone have the 'F' drill bit needed to install Boulder Bars? Or anyone know of a PHX area source for them?

Thanks,

Todd

_________________
95 YJ 2.5" RE lift and 32's, Posi-Lock, 4.10's with a Tru-Trac up front, M8000 winch, CB, gear and what have you...
RIP: 02 KJ LE

Try sears. they keep them by the die and tap stuff as that is what you would normally use that bit for.

If not, you can get away with a .25 inch as the F is .257 in reality. I broke both F bits I had and had to finish with the .25 and it worked out fine.

_________________
2008 Unlimited Rubicon - 3.5" AEV/Nth lift - 35" MT/R with Kevlar - AEV Wheels - York OBA
2008 Patriot - Fuel Saver

Todd, I have one if you need to use it. I PM'd you my cell number.

_________________
Kevin
AD5VG
Just another red Jeep in the world...
L.O.S.T. #KB051963

The boulder bars website also mentions getting one from them for $2.00. It'll probably take a while to get but as a last resort it would work.

*EDIT: Duh. Never mind you said PHX area source.

I'll give Sears a shot first. Thanks everyone.

TL

_________________
95 YJ 2.5" RE lift and 32's, Posi-Lock, 4.10's with a Tru-Trac up front, M8000 winch, CB, gear and what have you...
RIP: 02 KJ LE