LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

question
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=4&t=11833		 Page 1 of 1
Author:  txkjkid [ Mon Aug 28, 2006 9:17 am ]
Post subject:  question
looking to make my 4x2 a 4x4 any suggestions yes or no how to anything
Author:  VTNomad [ Mon Aug 28, 2006 9:19 am ]
Post subject:  Conversion
Take it to the dealer, trade it in.
Author:  Jeger [ Mon Aug 28, 2006 9:45 am ]
Post subject: 
I would start checking local junkyards, places that sell rebuildables etc. Find out what parts you need and post it in the parts wanted section here. So what will you need? Transfer case, front diff, front drive shaft, maybe a different rear driveshaft, halfshafts, transfer case linkages, maybe a new center console?, either lots of patience to save some money, or lots of money to get your parts quick.

Then you can start on the lift kit, offroad tires, lockers, skid plates, rock rails, etc. :lol:
Author:  gone_jeepin [ Mon Aug 28, 2006 2:54 pm ]
Post subject: 
for the price and effort its gonna take to convert, u might as well trade it in. But if ur gonna do it anyway i say go all out and do a SFA conversion!!!
Author:  PitViper [ Mon Aug 28, 2006 5:25 pm ]
Post subject:  Re: Conversion
VTNomad wrote:
Take it to the dealer, trade it in.



Thats how i did it... worked good... Well I sold the 4x2 to my dad but still same thing... :D
Author:  Jeger [ Mon Aug 28, 2006 6:09 pm ]
Post subject: 
There is a certain amount of pride in doing something yourself. If you were planning on doing this yourself and really want to do it I say go for it. If it is sctrictly a matter of money or time, figure out how much you will lose on a trade in, and compare that to how much the parts are going to cost you. The trade in is a sure fire thing so if you want to play it mostly safe that is definantly the way to go. Let us know how it goes
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/