If you keep the tire around 29.7" and less than 10" wide with the longer rear shocks you'll be good.
Otherwise, they will rub, nomatter what lift.
http://www.thefergusons.us/kj/kj.htm
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Lifts W/out rubbing http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=4&t=12309 |
Page 1 of 1 |
| Author: | Maximum Carnage [ Mon Sep 11, 2006 2:02 pm ] |
| Post subject: | Lifts W/out rubbing |
What lift can you put on a 2002 Libby without a rubbing? I’ve read several posts and most of them seem to have some rubbing or don’t mention anything about it. I don’t want to cut or ruin in any way the facial, fenders, ect… I’m looking to get a 2.5” Daystar or the Rusty lift. Any suggestions would help. |
|
| Author: | gone_jeepin [ Mon Sep 11, 2006 3:37 pm ] |
| Post subject: | |
No lift is gonna cause rubbing on the bumper. However if you try and fit too large of a tire you wil get the rubbing. What a lift can cause is upper ball joint contact with the spring. This causes the upper ball joint to rip. I haven't heard of many people with these problems with the daystar lift, so u should be ok. |
|
| Author: | jeepkj02 [ Mon Sep 11, 2006 5:01 pm ] |
| Post subject: | |
You should stay away from Rusty's spacer lift. It's the same as the Rocky's dreaded OTT lift. Daystar is a much better spacer lift. |
|
| Author: | unixxx [ Mon Sep 11, 2006 6:18 pm ] |
| Post subject: | |
Check out this page: http://en.wikibooks.org/wiki/Jeep_Liber ... s_%26_Rims It'll tell you what does and doesn't fit without trimming. |
|
| Author: | the1jferg [ Wed Sep 13, 2006 3:48 pm ] |
| Post subject: | |
If you keep the tire around 29.7" and less than 10" wide with the longer rear shocks you'll be good. Otherwise, they will rub, nomatter what lift.
http://www.thefergusons.us/kj/kj.htm |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|