Hey Ya'll,
I hope someone could help me out. I went to install the Rusty's 2.5" spacer kit the other day and it wont fit. After I put the space on the front shocks, there is no way (that I can see) of getting the Y bracket (clevis bracket) back onto the strut. I used and spring commpressor and it did nothing. Any ideas?

_________________
-Jeep by Al's Upper A-Arms
-ARB Bumper
-IPF Aux lights
-Frankenlift 2 Premium (OME all four corners)
-General Grabber AT2
-All J Products Rock Rails
-Hidden Hitch W/D ring
-K&N Cold Air Intake
-Airade Throttle Body Spacer
-Flowmaster Delta 50 Muffler
-Jet Performance Stage 2 Chip
-3" striaght pipe off the muffler

I had to losen the lower a-arm bolts to let it drop down all the way. Bad news is it still takes two people to get the a-arm and lower clevis to line back up to get the bolt in.

LARGE pry bar

yea i had to do the same thing with mine. and yea , your gunna an extra hand to get the a-arm back on.

_________________
2002 liberty sport 4x2
rusty's 2.5" spacer kit
AR 15x8's wrapped in 31" AT's
K&N FIPK Intake
a few sounds mods and that's it.