| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Flowmaster Super44 http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=4&t=27229 |
Page 1 of 1 |
| Author: | jeepkj02 [ Tue Dec 04, 2007 10:05 pm ] |
| Post subject: | Flowmaster Super44 |
Just installed the Flowmaster Super 44 Off-Road Series muffler, here is a sound clip:
Enjoy! |
|
| Author: | DryBones [ Tue Dec 04, 2007 10:31 pm ] |
| Post subject: | |
sounds great! now how about a drive by? |
|
| Author: | _UnLiMiTeD_ [ Sat Dec 08, 2007 2:04 pm ] |
| Post subject: | |
so how do u like the sound? you never did anwser in the other forum |
|
| Author: | jeepkj02 [ Sat Dec 08, 2007 2:34 pm ] |
| Post subject: | |
It sounds great. I really like the performance and sound. Buy it, you won't be disappointed. |
|
| Author: | LibertyGuy [ Sat Dec 08, 2007 2:41 pm ] |
| Post subject: | |
Sounds awesome! My 40 series sounds a bit deeper & louder. Not sure if it's just the video clip or maybe because I also have the intake combo. Love driving with the Flowmaster rather than stock. |
|
| Author: | PaU-MWolverine [ Sun Jan 13, 2008 12:49 pm ] |
| Post subject: | |
DryBones wrote: sounds great! now how about a drive by?
I whole-heartedly agree on both counts!!! |
|
| Author: | xnavy74 [ Tue Feb 05, 2008 8:59 pm ] |
| Post subject: | |
jeepkj02 wrote: It sounds great. I really like the performance and sound. Buy it, you won't be disappointed.
How are you on interior noise? I know it ranks high on flowmasters site. |
|
| Author: | jeepkj02 [ Wed Feb 06, 2008 11:58 am ] |
| Post subject: | |
It's not too loud, its loud in the morning (cold start), but once it warms up, it not very bad. On a scale from 1 to 5 (5 being the loudest), I would say 2-2.5. Maybe I just go use to it, idk. |
|
| Author: | p.spence [ Tue Jun 01, 2010 4:56 pm ] |
| Post subject: | Re: Flowmaster Super44 |
Can you give a description of your install? Connectors used, etc? Did you weld into the existing pipe and carry out under the rear bumper? |
|
| Author: | DirtyKK [ Tue Jun 01, 2010 6:43 pm ] |
| Post subject: | Re: Flowmaster Super44 |
p.spence wrote: Can you give a description of your install? Connectors used, etc? Did you weld into the existing pipe and carry out under the rear bumper? this thread is years old buddy. your best bet is to get a muffler shop to weld it on. its honestly not that much. |
|
| Author: | Cherrie 274 [ Tue Jun 01, 2010 6:50 pm ] |
| Post subject: | Re: Flowmaster Super44 |
I had my magna flow installed for 20.00, was to cheap to pass up.And done in 10 minutes. |
|
| Author: | BennyMigs [ Thu Jun 17, 2010 7:31 am ] |
| Post subject: | Re: Flowmaster Super44 |
What are the inlet out let specs or the parts#? |
|
| Author: | MKenney24x [ Sun Mar 20, 2011 12:12 pm ] |
| Post subject: | Re: Flowmaster Super44 |
You need 3 2.5 inch exhaust clamps, and atleast 18" 2.5 piece of pipe, and a sawzall. I was afraid to weld mine on because where I had to cut it off on my 2005 there was not much room for it to be cut again if I need another muffler |
|
| Author: | MKenney24x [ Sun Mar 20, 2011 12:15 pm ] |
| Post subject: | Re: Flowmaster Super44 |
And the specs are 2.5 center 2.5 right |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|