look at top of picture. very very easy, i mean i did it for sh#t sake.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Power chip and cold air intake? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=4&t=35110 |
Page 1 of 1 |
| Author: | zzack92 [ Sat Aug 16, 2008 9:35 pm ] |
| Post subject: | Power chip and cold air intake? |
Where does the power chip go under the hood and if i put in a cold air intake would it be in the way? also hows the install on a cold air intake? |
|
| Author: | jsc7002 [ Sat Aug 16, 2008 10:00 pm ] |
| Post subject: | |
the cold air intake is easy to do shouldnt take more than 30min and thats taking your time |
|
| Author: | KY Liberty [ Sat Aug 16, 2008 10:19 pm ] |
| Post subject: | |
You would actually be better off simply putting in a good drop in filter. An upgraded throttle body will help too. If you go with a "cold air" intake you will need to do the $4 gutter pipe mod, or a hood to benefit over a good drop in. The install of the drop in will take a couple minutes. As stated above, the "cold air" install should take you less than 30 minutes and is pretty easy. The piggy back chips are a joke. Unlike the manufacturer of them, I actually dyno'd the stage 1 with the 3.7 in a KJ. It made 5 peak hp less than stock. If you want to get more out of the 3.7 from programming, you need a B&G flash. It actually made a big difference on the dyno. |
|
| Author: | rangerd77 [ Sat Aug 16, 2008 10:20 pm ] |
| Post subject: | |
look at top of picture. very very easy, i mean i did it for sh#t sake.
|
|
| Author: | zzack92 [ Sun Aug 17, 2008 1:04 am ] |
| Post subject: | |
alright thanks guys whats this B&G Flash tho? |
|
| Author: | JJsTJ [ Sun Aug 17, 2008 9:36 am ] |
| Post subject: | |
Don't waste your money or time on a "CAI". Unless you are drawing the air in from a cooler than underhood source you are Not getting cold air. The factory air box flows more than needed for a 3.7L and draws it in from under the hoods edge where air is cooler than underhood. Drop a $45 Amsoil Ea series air filter in the stock box and move on to other mods that work. Several have used the "gutter" mod to draw even more cool air into the stock box from the grill area. Search for "gutter" and it should bring up some posts on the subject. Keeping the stock air box will also allow you to keep the water fording capabilities of the factory setup. |
|
| Author: | KY Liberty [ Sun Aug 17, 2008 8:28 pm ] |
| Post subject: | |
zzack92 wrote: alright thanks guys whats this B&G Flash tho?
They actually reprogram your engine computer instead of lieing to it by using a chip to change information from sensors. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|