has anyone seen these liberty turbos they look shady to me, but does anyone know of any turbo system for libertys i know you can make a trubo for any engine, but a custom turbo would be really big bucks to do it right.
http://shop.ebay.com/?_from=R40&_trksid=p3907.m570.l1313&_nkw=jeep+liberty+turbo&_sacat=See-All-Categories

_________________
Jeep JKU 08
buick GS convertible 71
Jeep GC wk2 2011

This has been discussed lots. You would have to do major work to the motor for a turbo not to destroy the motor. Pistons, bearings connecting rods etc...if I remember right. Someone will jump in with the correct info.

Terry

_________________
2011 Ford F-150 XLT 4X4

Look up Supercharger / Kenne Bell on this board. Much discussion. Kenne Bell was to make one for the 3.7. It turned out unmarketable due to the 3.7 would just get fried. Like Fulltimer states, Pistons, Rods, bearings and many other moveable parts just can't be tweaked much more without full on replacement with something better.

4BTA swap? Anyone?

_________________
IceColeNH #JC060619
03' Renegade
Al's Arms.
3 inch lift; Rusty's springs all around, Rancho struts + 4 electrical conduit washers up front. Old Man Emu in rear.
Moog K3199 in the lowers
General Grabber AT2 - 245 75 16 "load E on a mawl crawler? You don't need those." tire dealer.
K&N Filter
Silverstar Ultras

do it right;
do it once;

it'll blow the piston rings off stock pistons

_________________
03 Renegade (Black)
177k miles 3.7L gas - 45RFE
Command Trac / 4.10s
Lift: ft. 790+ rr. JBA4+
The last of the TrailReady Front&Rear Bumpers and TR Rock Rails
Jarhead Offroad light covers
31x10.5R15 RedLetter Grabbers on Blackrock Dunes
L.O.S.T #KD098632