Hello all, bought mine after a trip to UK and having one as a rental in 2007.
Mine is set up w/the tow package, have had very few probs w/the jeep.
I do "always" have issues w/the tranni reseting itself after I tow, or make my anual trip to Kamloops/Sun Peaks in British Columbia. Three mountains passes in about 3 hours. Seems to confuse the darn thing. Then It just does not want to shift.
Most recent codes of P0715 and P0700. I usually just drive moderately for a few days and the system corrects itself.
I am certain this is all electrical rather than mechanical. Makes me crazy. Any thoughts?

Welcome!

_________________
Steve
2018 RAM 1500 Rebel
2003 KJ
Mods:Exterior: Frankenlift + 2 extra rear iso, JBA UCAs, ARB Bumper w/XRC8, Safari Snorkel, 265/75/16 AT, Mopar Skids, Boulderbars, RL Gecko Sport Rack
Interior: Infinity Reference speakers, 12" Alpine Type R Sub, Alpine radio, Gauge Pods (Oil, Volts), Cobra Cb, All J Interior Rack

Welcome aboard. Happy Jeeping!

_________________
2010 Liberty 4x4 Limited
Trailer Tow Group, Sunroof, Skid Plates

1999 Wrangler Sahara
2" Teraflex lift with flexarms, ARB air lockers Front/Rear, Skid Plates, BFG 31x10.50 ATKOs

Welcome!

_________________
-------------------------------------
03 Jeep Liberty Renegade, Black - SOLD
95 Jeep Cherokee XJ, 2 door 5 speed, Black

Welcome Mark!

Be sure to post those codes in the crd or general section, the CRD guys may not frequent this area as quickly as you may wish to figure out the issues!

_________________
03 Renegade (Black)
177k miles 3.7L gas - 45RFE
Command Trac / 4.10s
Lift: ft. 790+ rr. JBA4+
The last of the TrailReady Front&Rear Bumpers and TR Rock Rails
Jarhead Offroad light covers
31x10.5R15 RedLetter Grabbers on Blackrock Dunes
L.O.S.T #KD098632

Welcome, Mark.

Ya, come join us in the "CRD. . . Love That Torque" section. Most CRD'ers rarely leave there.

From the DTC (Diagnostic Trouble Code) list in the CRD Tech section:

P0700-TCM DTC .
P0700-TRANSMISSION CONTROL SYSTEM (MIL REQUEST).
P0715-INPUT SPEED SENSOR 1 CIRCUIT

Here is the link to the Thread: viewtopic.php?f=98&t=40073

IIRC, the Input Speed sensor is on the exterior of the transmission, near the back on the passenger (starboard) side. You may have a loose wire, or some crud in the connector or something. There are other, more knowledgeable people in the CRD section that could probably offer you more help if you post there, since the tranny on the CRD is specific to that model.

_________________
In this war of lines, so many have been crossed. Where will it all stop?

2006 Deep Beryl Green CRD Sport *SOLD 1/22/12*
Provent, V6 Airbox, Fumoto, Samcos, GDE ECO & TCM Tune, Euro JK TC, Magnaflow Catback
245/70/16 Destination A/T's
Boiler's Radiator Skid Plate
Jeepin' By Al 2.5 inch Adjust-A-Strut Lift, JBA Gen 4.5 UCA's (6/5/10)