Ball Mount for CB Antenna

allscan · **Posted:** Mon Oct 02, 2006 6:45 pm

Well I finally got the courage to drill a few holes in the side of my Liberty for a ball mount. I put it on the rear passengers panel, mostly because I didn't want to drill close to the fuel cap. I don't have any pictures during the install (too overcast this past Saturday) but here is the finished product.

Up close:

From front of Jeep:

Overhead from my apartment balcony:

nolakj · **Posted:** Mon Oct 02, 2006 8:42 pm

Very clean install. How did you run the wire?

allscan · **Posted:** Mon Oct 02, 2006 10:13 pm

I had to pull the inside panel to access the back of the mount, this let me run it all the way up front underneath the plastic trim. Before with my mag-mount anyone getting in the back seat had to fight off the coax, now you wouldn't know it was there.

Ball Mount for CB Antenna

Who is online