Just rip out the whole stero and start from scratch
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Help! http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=45&t=10695 |
Page 1 of 1 |
| Author: | 05JeepKJ [ Sat Jul 22, 2006 9:09 pm ] |
| Post subject: | Help! |
Im installing a CB radio and sub in my jeep and i cannot find a way through the firewall. I was going to let it go through with the steering wheel column but i dont think its safe to do that. I found the stock wires that go through the firewall but i can fit the radion wire or the thick amp wire. Anybody have any suggestions? |
|
| Author: | ATXKJ [ Sat Jul 22, 2006 9:21 pm ] |
| Post subject: | |
Try this http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?t=1389&highlight=wire+firewall |
|
| Author: | 05JeepKJ [ Sat Jul 22, 2006 11:36 pm ] |
| Post subject: | |
Thanks for the link it help me figure it out. Now I have another question how do you wire up a sub to the KJ. I have the power wire wired up to the battery but i forgot how to do the rest. I have a mono sub with 800 watts. Any suggesstions? Thanks. |
|
| Author: | 05JeepKJ [ Sun Jul 23, 2006 6:51 pm ] |
| Post subject: | |
Where is the stock amp on the Kj. Like the WJ's are under the passenger side rear seat. |
|
| Author: | unixxx [ Mon Jul 24, 2006 12:42 am ] |
| Post subject: | |
With the standard audio package the stock amp is built into the head unit. In the premium audio package the configuration is the same, only the audio is further amplified by amps built into the front door speakers. For the audio portion of your wiring I believe you'll want to combine the left and right channel, run the combined signal through a low pass filter, and then run that into your mono amp. Many amps will have a built in low pass filter and some may even combine the channels for you. |
|
| Author: | JMLoughrey [ Mon Jul 24, 2006 12:51 am ] |
| Post subject: | |
Just rip out the whole stero and start from scratch
|
|
| Author: | unixxx [ Mon Jul 24, 2006 1:03 am ] |
| Post subject: | |
JMLoughrey wrote: Just rip out the whole stero and start from scratch
That's what I'm on my way to doing Only got the speakers left....
|
|
| Author: | 05JeepKJ [ Mon Jul 24, 2006 11:34 am ] |
| Post subject: | |
i dont want to replace the whole system since im on a budget with the lift and tires. So far im stuck on the RCA wires that connect the amp to the speakers. I have power and its grounded but dont know where to put the speaker wires. I have them hooked up on the amp but im not quite sure where to put it on the other end. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|