LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

Ball Mount for CB Antenna
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=45&t=13053		 Page 1 of 1
Author:  allscan [ Mon Oct 02, 2006 6:45 pm ]
Post subject:  Ball Mount for CB Antenna
Well I finally got the courage to drill a few holes in the side of my Liberty for a ball mount. I put it on the rear passengers panel, mostly because I didn't want to drill close to the fuel cap. I don't have any pictures during the install (too overcast this past Saturday) but here is the finished product.

Up close:
Image

From front of Jeep:
Image

Overhead from my apartment balcony:
Image
Author:  nolakj [ Mon Oct 02, 2006 8:42 pm ]
Post subject: 
Very clean install. How did you run the wire?
Author:  allscan [ Mon Oct 02, 2006 10:13 pm ]
Post subject: 
I had to pull the inside panel to access the back of the mount, this let me run it all the way up front underneath the plastic trim. Before with my mag-mount anyone getting in the back seat had to fight off the coax, now you wouldn't know it was there.
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/