| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| trouble with cb when jeep is runnin http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=45&t=17724 |
Page 1 of 1 |
| Author: | emt446 [ Thu Feb 15, 2007 6:45 pm ] |
| Post subject: | trouble with cb when jeep is runnin |
hello, i am having troble with my cb radio system. when the car is off i can use it no prob. but when i start the jeep up and try to use it the warning light for my antenna comes on. i have played with the swr knobe and my swr is 1.5. dose any know what might be the prob |
|
| Author: | emt446 [ Fri Feb 16, 2007 6:32 pm ] |
| Post subject: | |
is their any one that can help |
|
| Author: | ATXKJ [ Fri Feb 16, 2007 8:11 pm ] |
| Post subject: | |
Don't know much about CB's - but general electronic troubleshooting - it sounds like either your ground or your voltage source changes when the engine's running - I'd put a meter on them and watch - see what the levels are - and if there are any spikes or drops as you switch things off and on. |
|
| Author: | Donkeykong [ Sat Feb 17, 2007 1:14 am ] |
| Post subject: | |
I'll second that... where did you tie your power supply for the CB into? If it's in the radios constant power source (the one that keeps your presets, and the clock on time) it might turn off when you turn the vehicle on... Other than that I can't think of anything else.... maybe a dome light? More information about the hookup would help.... pictures would help even more..... just check with a multimeter (make sure it's volts DC) that you have power to the CB when the vehicle is on.... and no power when it is off... Trying to help.. -Mark |
|
| Author: | FastTRX [ Mon Apr 16, 2007 11:23 pm ] |
| Post subject: | |
On our last run I discovered my CB was not working and when we finally got it hooked up I kept blowing the fuses in the power cord of the CB. The unit is a Cobra 29 LTD Classic. I was originally running it thru a cigarette lighter power hookup, but it was blowing the fuse and not working when the KJ was turned on. With the Jeep off it would work crystal clear. I thought it may have been a bad ground, but we took the bottom floor side panel off (NOT door panel) and grounded it to a bolt that was suggested as a "factory ground" by a member of the group. We still had the problems. I think it may have done with the fuse we were running the power off of but I cant be sure. Could the CB unit be bad?? I guess my question is...what fuse should I run the power source off? I'm pretty sure my ground is not the problem but my knowledge to electronics/power sources/fuses is very minimal so I could be very wrong in my assumption. Can anyone help? |
|
| Author: | AndySRT [ Mon Apr 16, 2007 11:33 pm ] |
| Post subject: | |
I think you just need a new power cord because we hooked it up the same way i have mine wired in and his fuse for the power cable to the CB kept poping. I'm thinking its the CB box because mine works fine. didn't you say you bought it used? we can try my CB in your libby next time or try someone elses. also I can bring my multimeter next time we go wheelin. |
|
| Author: | FastTRX [ Mon Apr 16, 2007 11:37 pm ] |
| Post subject: | |
AndySRT wrote: I think you just need a new power cord because we hooked it up the same way i have mine wired in and the fuse for the power cable to the CB kept poping. I'm thinking its the CB box because mine works fine. didn't you say you bought it used?
Yup and it very well could be the case. Maybe I should head to the local truck stop to see if they have a new power cord? I can't see spending more money on another Cobra right now, so I may try a new cord. If not than I'm guna wait for a while and buy a new one. |
|
| Author: | FastTRX [ Mon Apr 16, 2007 11:39 pm ] |
| Post subject: | |
AndySRT wrote: we can try my CB in your libby next time or try someone elses. also I can bring my multimeter next time we go wheelin.
Sounds good. I'm guna go shopping, I need a new antenna anyways so I'm guna look at some options. You guna make the run on the 6th (Sunday)? |
|
| Author: | AndySRT [ Mon Apr 16, 2007 11:42 pm ] |
| Post subject: | |
we need to make a new thread about that because its coming up soon and i still haven't desided if i want to go then or the 19th and run till 9pm. |
|
| Author: | FastTRX [ Mon Apr 16, 2007 11:44 pm ] |
| Post subject: | |
AndySRT wrote: we need to make a new thread about that because its coming up soon and i still haven't desided if i want to go then or the 19th and run till 9pm.
Do both!!  I can def. do the run on the 6th if we get a few people, but I just need to get this stupid CB problem fixed so I can use the dang thing!!
|
|
| Author: | Fulltimer [ Tue Apr 17, 2007 11:54 am ] |
| Post subject: | Re: trouble with cb when jeep is runnin |
emt446 wrote: hello, i am having troble with my cb radio system. when the car is off i can use it no prob. but when i start the jeep up and try to use it the warning light for my antenna comes on. i have played with the swr knobe and my swr is 1.5. dose any know what might be the prob
How about some info: 1. Is radio grounded well? 2. Is antenna grounded well? 3. Does it transmit & receive ok when you are driving? Terry |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|