i am going to be rewiring my wiring this thanksgivingish, and had a couple questions...

1: can i run one wire to the battery and connect three wires to that one wire and still have my lights turn on and off individually via switches?

2. i will be drilling through the firewall b/c i don't like my current wire-in-cab situation, and need to know what to use to keep it water-tight while still having the capability of removing wires from the firewall (i.e.-any type of rubber grommet that i can place in there and then apoxy it up, but i can still move the wires in and out of the hole)?

You can run a large guage feeder wire to the battery and split off of that and have each split off wire run through it's own switch to control the individual circiuts. Just be sure to use a large enough feeder that can handle the current draw if all attached circiuts are on at the same time. A fuse would be a great idea as well for the feeder, and then a fuse for each circiut.

_________________
2005 Jeep Liberty Limited 4x4
BFG A/T KO's
Custom roof rails

http://www.cardomain.com/ride/2935427