I got 4 new door speakers for Christmas and an amp. My problem is wiring the speakers threw to door to back of the jeep.
any ideas????

_________________
2004 jeep liberty 3.7l
general grabber at2
K&n cold air intake
dynomax cat back exhaust
front tow hooks
hitch with D ring shackle
LED interior
Pioneer speaker upgrade
some skids
alpine head unit

the speaker wires are behind the radio if you have the standard system.. You can even get a "forward" and "reverse" harness that will allow you to pre wire and run to the amp so no need to run wires into doors. If this isn't clicking, I highly recommend paying a shop to do it for you.

_________________
2006 CRD http://www.UtahPowderCoatings.com/ http://www.gorecon.com/ I'm kind of a big deal.
RL rear bumper, ARB front bumper, Mile Marker winch, Power Tank, Skids by Mopar & Skid Row, RL Super Skink Sliders, 235/85R16 MTR, Air Flow Snorkel, DTT, 4.10 gears, Frankenlift II, Katskin leather, JL Audio stereo, Rosen video.

Yeah, you don't need to run new wires unless you never had speakers there in the first place. Just use the factory wires already there.

_________________
04 Silver Subaru Forester 2.5XT turbo (300+ AWHP)
02 Green Jeep Liberty Limited (OME lift, with MOABs)
Liberty pic --> http://www.sixthsphere.com/storage2/ima ... mlff6d.jpg

you have to put in new speaker wire to the amp, im not going to put 120 watts RMS threw the factory wire,
i just wanted an idea of how to run it threw the door to the inside of the jeep

_________________
2004 jeep liberty 3.7l
general grabber at2
K&n cold air intake
dynomax cat back exhaust
front tow hooks
hitch with D ring shackle
LED interior
Pioneer speaker upgrade
some skids
alpine head unit

you're putting amped speakers into the door? If you're not going to use the old speaker wires I would use those to pull the new ones through the door if you're able. I've never really looked at them but I know they go through that flexible tube that goes from the door frame to the door. I'm not sure how tight an opening that is, but if you tape the new wires to the old you might be able to pull them through.

_________________
04 Silver Subaru Forester 2.5XT turbo (300+ AWHP)
02 Green Jeep Liberty Limited (OME lift, with MOABs)
Liberty pic --> http://www.sixthsphere.com/storage2/ima ... mlff6d.jpg

Not hard at all, just pull the boot that runs through the door while you have the speakers out and run them through and the most you will have to collapse one of the plug walls. Very easy to do.

_________________
No longer a CRD or Jeep owner. Selling everything I have, needs to go as I need the room for a project.