Anyone mounted a license plate cam and had to route the cable through the jeep? just wonder where the easiest place to run them is especially through the hatch

_________________
2008 KK Limited
Stock for now

Run your wiring where the factory trailer wiring harness goes. Through the floor at the right rear(there is a grommet there), under the trim along the right side and out the trim by the glove box.

http://www.mopar-accessories.com/en-US/82210895AB/partinfo.aspx?DivisionId=1&Year=2009&VehicleId=24&CategoryId=1001&GroupId=2015&SubGroupId=3321&pc=40501
This was posted awhile ago on another post...the pdf in the link shows how to wire. I'm looking to do the same as you....hard to find much info out there with pics or tips on wiring...etc.

I mean installing a backup camera on a car that doesn't already have one. I'm considering adding one to my car. There's an empty slot(well, not empty, covered..) like when you buy a car without all possible exterior options in the perfect place for one.

__________
Backup Camera System

update

http://www.mopar-accessories.com/en-US/82212350AB/partinfo.aspx?DivisionId=1&Year=2010&VehicleId=24&CategoryId=1001&GroupId=2015&SubGroupId=3321&pc=79362

_________________
With enough fabbing, time & $, it's certainly possible.
That being said, it's like boinkin' your sister...just because you can, doesn't mean you should.

I got a lincense plate camera for Christmas and garmin 5000 for display! Howrver I haven't installed it yet. One dilema I have is on my RL bumper I have a generic light that mounts on the top two holes of the license plate... same place I would mount the camera.

_________________


05 CRD Sport Dark Kahki

RRO: Adventure Rack/Rails ** MOPAR: Skids/Renny Flares & 255/75r17 (32.1) BFG M/T on JK wheels ** ARB: Bumper/IPF lights/790/948/shocks ** GDE: TCM/Hot Tune ** ROCKLIZARD: Super Sliders/Komodo Bumper

My Build Thread
US Army Infantry