LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

wires thru firewall
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=45&t=61434		 Page 1 of 1
Author:  steve03sport [ Tue Jun 28, 2011 7:38 pm ]
Post subject:  wires thru firewall
can anyone give me some info/how to or where in fire wall is the spot to run wires to the knee panel
Author:  infernicus [ Tue Jun 28, 2011 8:03 pm ]
Post subject:  Re: wires thru firewall
Super Easy.
http://en.wikibooks.org/wiki/Jeep_Liber ... enetration
Author:  steve03sport [ Wed Jun 29, 2011 9:10 pm ]
Post subject:  Re: wires thru firewall
ok how do i get the wires from my roof basket into the jeep???? please help or show
Author:  NewOldTimer [ Thu Jun 30, 2011 8:28 pm ]
Post subject:  Re: wires thru firewall
steve03sport wrote:
can anyone give me some info/how to or where in fire wall is the spot to run wires to the knee panel


Looks like I really need to take some additional photos of my wiring installation........ :banghead: :banghead: :banghead:

There is a flat rubber plug on the firewall that gives easy access to the engine compartment.
Just follow the main wire bundle to the firewall, and you should see a smaller bundle just beneath it.
Use a phillips screwdriver to punch a starter hole thru this grommet, and start pushing wires.

Your wiring will enter the engine compartment just above the the inner fender directly below the
power brake assist.
Author:  tZac [ Fri Jul 01, 2011 3:58 am ]
Post subject:  Re: wires thru firewall
Wires can enter the cab thru the firewall right above the go pedal.

Image

or behind the fuel filter if you are looking from engine compartment

Image
Author:  steve03sport [ Fri Jul 01, 2011 10:20 am ]
Post subject:  Re: wires thru firewall
idk... but i found a way thru and got my 2 6ga wires thru from inside cabin its under near the left side, following another group of wires. almost above where clutch would be if it was a 5 speed
Author:  NewOldTimer [ Fri Jul 01, 2011 8:46 pm ]
Post subject:  Re: wires thru firewall
steve03sport wrote:
idk... but i found a way thru and got my 2 6ga wires thru from inside cabin its under near the left side, following another group of wires. almost above where clutch would be if it was a 5 speed


Sounds like you're making progress. :rockon:

Take plenty of photos. :SOMBRERO:
Author:  CoopaTroopa [ Fri Aug 19, 2011 8:31 am ]
Post subject:  Re: wires thru firewall
dont know if you still need it but here is how I did it... viewtopic.php?f=45&t=59109 Bottom of the page and you can pretty much follow the pics to get an idea if where the wires go even though they are under the trim
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/