Ugh, I have never dealt with the crap in any vehicle I've owned. I want to put a nice set of components in the front of my KJ but I'd also like to run new wiring instead of using the factory stuff. The rubber boot between the door and the vehicle has this stupid modular plug in it that won't allow any wires to be passed through. What is the solution for this? Do you pretty much have to remove the door and drill through it?

Does anyone know what the wire gauge is of the factory wiring?

_________________
2012 Jeep Wrangler Unlimited Sport - 6 speed manual, 3.73's, bone stock

2006 Jeep KJ Sport - GONE
OME Suspension Lift, ARB Bull Bar, 245/75R/16 Goodyear Duratracs, Mopar Light Bar, Front & Transmission Skid, Galaxy CB, Rola Roof Rack

I ran my wire trough the plastic block by cutting one of the dividers out anough to allow the wire to pass through. Easy as pie. Used a shot of silicon sealer to close up the smace around the wire also.

_________________
No longer a CRD or Jeep owner. Selling everything I have, needs to go as I need the room for a project.