riptricket wrote:
So their diagram is confusing..
Does the resistor just go on ground or to both ground and hot... The line they have is non specific.
Don't really want to burn up my new LEDs.
Thanks much of the help.
The resistors should be wired between the hot wire feeding the bulb socket and the ground wire leaving the bulb socket. Since the Jeep turn signals are separate from the brake lights, it is simple. The resistor simply adds resistance to the LED bulb to make the body computer think the OEM bulb is still in place.... This has to be done at each location where an
LED turn signal bulb is being used. It is not required on any of the other circuits since they do not flash when energized, brakes, running lights, etc...
_________________
Supporting Vendor and Moderator of LOST05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount98 Dodge Cummins 24 Valve