riptricket wrote:
I am getting an ecco backup alarm and am wiring it in to the taillights backup so it kicks on when in reverse.
Thanks in advance.
FSM says its WT/GY (white/gray) wire. See page 8W-51-4, in the "8W Rear Lighting" section.
Where are you wanting to tap into the circuit at?
If you pull one of the rear tail lamp assemblies, it would real easy to identify and tap into the BU circuit wires. Only two small torx screws holding it in place.
You could then route a new wire down to underneath the rear of the vehicle wherever you want to mount your BU alarm....
_________________
Supporting Vendor and Moderator of LOST05 Jeep Liberty CRD Limited
Ironman Springs/Bilstein/Shocks
Yeti StgIV Hot Tune
Week's BatteryTray
No FCV/EGR
Samcos/ProVent
SunCoast/Transgo
Carter Intank-pmp
2mic.Sec.Fuel Filter
Flowmaster/NO CAT
V6Airbox/noVH
GM11 Bld.fan/HDClutch
IronrockArms/wwdieselMount98 Dodge Cummins 24 Valve