Hi all,

I've got 2 short block assemblies with a dropped valve in one piston, as well as 3 used pistons I planned to use to get the short block put back together ready for a head. Never got around to it, and I never needed to for any project vehicle. Now these days with complete engines being so cheap at the pull it yourself junkyards I've just been grabbing complete spare engines when I needed one.

I'm pretty much to the point that I can't see wanting to replace a piston to use a bottom end since I have complete spares here. Is anyone these days messing with putting together engines from short blocks/rebuilding them? Kinda figure at this point they ought to just go out in the next scrap run so I can have the room back in the shop.

Thoughts?

_________________
http://www.Colorado4Wheel.com
"Its not about what you can DO with your Jeep, its about where you can GO with your Jeep."
Knowledgeable - But Caustic