Hello you all, Happy new Year.

My 2005CRD (276K miles) died on me while going to dinner one night last week. The technician diagnostic was that the ECM-PCM was the faulty one. I was recommended to a company called "Car Computer Exchange" located in Raleigh, NC. for a re-manufactured replacement.

Have any one have had experience with them or has used them before? Has anyone another recommendation?

Any suggestion is wellcome,

Thanks
Sergio

_________________
Sergio05CRD

I used autoecms 800-900-0194 autoecmstore.com
Good luck to you

_________________
05 CRD Owner. Diesel good. Gas bad.

Find a good used one with the same last 3 digits in the part # and send it in to Green Diesel Engineering. He'll reprogram it for you but he will need your VIN and each of the 4 injector codes (6 digit alphanumerical) located on top of the injectors.

_________________
GDE FT Ecotune, EHM, Weeks kit stage 1 & 2, Carter 4600 lift pump, Upgraded tranny, Fishing boat hauler!
New at 164K: head gasket, rockers, exhaust valves, ARP head studs, Injectors, 5v Bosch glow plugs, water pump, timing everything, serpentine everything,
New at 225k: new head, timing belt

I can program a used ECU if you get one from ebay, car-part etc.

https://youtu.be/rLIqALEaN4I

_________________
http://www.Colorado4Wheel.com
"Its not about what you can DO with your Jeep, its about where you can GO with your Jeep."
Knowledgeable - But Caustic