What did you do to your CRD today?

mikmaze · **Posted:** Wed Nov 16, 2011 6:52 pm

put some new sneakers on the crd today, set of 235 70 16's, look alot like the 225 75 16's that came off, but a lot more tread!

CRD05il · **Posted:** Wed Nov 16, 2011 11:44 pm

Let see a picture of her new sneakers

irollgen4s · **Posted:** Thu Nov 17, 2011 3:11 pm

Brakes have been sticking intermittently and i'm not sure why, just had a full brake job done by a shop. Also tried to play around a little bit on some dirt, but the stupid Brake lock differential ruins that possibility.

I know you can turn the basic traction control off on our libby's, but i want to know if there is a way to completely disable the BLD(brake lock differential) without having to pull the ABS fuse(taking away ABS and traction control should i want it). BLD is just a pain in the :furious:

and doesn't let me slide around, AT ALL when i want to. and pulling the fuse for those occasions is just a pain. I thought putting a locker in would change this, but i don't think it actually would. Then again I'm not sure. Any input?

WolverineFW · **Posted:** Thu Nov 17, 2011 10:50 pm

Wire in a switch in the cab to disable ABS fuse instead of pulling it out.

irollgen4s · **Posted:** Thu Nov 17, 2011 11:03 pm

yep, talked to my uncle and a few fellow jeep owners about it already. everything's coming home with my dad to wire it in tomorrow, just gotta grab a couple 40amp fuses.

METCRD · **Posted:** Fri Nov 18, 2011 1:23 pm

Installed a very inexpensive flowthrough muffler and removed the restriction on the exhaust pipe before and after the stock muffler. Still trying to get used to the exhaust sound, I think I like it.

ajdance · **Joined:** Tue Jun 07, 2011 11:49 pm **Posts:** 11

Today I cleaned the dirty, filfty, carbonized MAP. My old Jeep is back!! Pulling a trailer out to Arizona next week so I'll see what the CRD is really made of.

dc3655 · **Joined:** Mon May 16, 2011 3:08 am **Posts:** 38

I re-installed the factory muffler because the sound of the straight pipe was getting to be too obnoxious. Next, I need to clean the MAP sensor if I only knew where it was. Any help would be appreciated.

racertracer · **Posted:** Sat Nov 19, 2011 7:20 am

dc3655 wrote:

I re-installed the factory muffler because the sound of the straight pipe was getting to be too obnoxious. Next, I need to clean the MAP sensor if I only knew where it was. Any help would be appreciated.

Read the noob guide. viewtopic.php?f=5&t=54207

RAF 3829 · **Posted:** Sun Nov 20, 2011 1:29 pm

Finally had the time to put the Steiger kit in the right rear door after the window dropped a few weeks ago. Had the window propped shut with a stick till I could get to it. Wasn't bad to do, took my time, next one should go a lot quicker when it happens.

fatweasel · **Posted:** Tue Nov 22, 2011 7:06 am

Hit a deer

racertracer · **Posted:** Tue Nov 22, 2011 8:21 am

fatweasel wrote:

Hit a deer

What's the damage report?

jinstall · **Posted:** Tue Nov 22, 2011 9:25 am

Ujoints in the rear shaft. sigh.

DynoPax · **Posted:** Tue Nov 22, 2011 11:46 am

U-joints on the rear DS
Winter tires
Mechanical fan removed
Switched to internal air intake

Next week-end:
Front brake pads
Service filter for Facet lift pump

irunmiles · **Posted:** Tue Nov 22, 2011 4:23 pm

New brake pads all around, and new rear calipers. Over 180k miles on the stock calipers before one went bad!

jinstall · **Posted:** Sun Dec 04, 2011 7:38 pm

Caliper bolts replacementr today, greased new u-joints and refitted the CAC hose the dealer install too far up on the neck, it was having blowby.

arengant · **Posted:** Sun Dec 04, 2011 8:17 pm

I finally installed my new fuel filter head! I think I bought it over 6 months ago...

And since it came with a new filter, I acutally did TWO things today, changed my fuel filter too! :ROTFL:

arengant · **Posted:** Sun Dec 04, 2011 8:17 pm

DynoPax wrote:

U-joints on the rear DS
Winter tires
Mechanical fan removed
Switched to internal air intake

Next week-end:
Front brake pads
Service filter for Facet lift pump

What are you doing for an internal air intake?

Greasey Bob · **Joined:** Tue Dec 14, 2010 3:34 am **Posts:** 228

What did you do with your old filter head because I could use one. I will send you some money for shipping via pay pal.

arengant · **Posted:** Mon Dec 05, 2011 7:19 pm

Greasey Bob wrote:

What did you do with your old filter head because I could use one. I will send you some money for shipping via pay pal.

PM sent

What did you do to your CRD today?

Who is online