I went out tonight to plug in my 01 Dodge with cummins and thought about the Jeep. I can not find the heater plug. Where are they hiding it. I got the manual out and it was no help. it said it was on the left side of the engine then in parentheses said on 3.7 L only. I know it says it is not required until it gets to 0 F. But the instant heat would be nice, wouldn't have to warm Jeep for so long in the morning. Just want to know.
Thanks
T

_________________
2005 Liberty CRD, Limited, loaded, Black.
2011 Dodge 2500, Laramie 4X4, crewcab, Cummins,
2011 Ford F-150 XLT
2018 Honda CRV
1987 GMC Jimmy
"T"

Plug is wrapped around the dipstick. Follow the stick down and you will see it wire tied.

Pablo
Thanks for the input. You were exactly right. It was there. I cut it loose and routed it towards the front of the Jeep. May have to reroute it, Still can not get to it without raising the hood
Thanks again
T

_________________
2005 Liberty CRD, Limited, loaded, Black.
2011 Dodge 2500, Laramie 4X4, crewcab, Cummins,
2011 Ford F-150 XLT
2018 Honda CRV
1987 GMC Jimmy
"T"

Should be enough cord to run it out near the opening near the tow hooks, just barely, and it tucks right back up really nice, most people poke it though the grille too.

K

_________________
'06 Midnight Blue CRD Sport
Born 5-06
Mopar Skids and Tow Hooks
Deer Killer Mod

Okay thanks I look at other options.

_________________
2005 Liberty CRD, Limited, loaded, Black.
2011 Dodge 2500, Laramie 4X4, crewcab, Cummins,
2011 Ford F-150 XLT
2018 Honda CRV
1987 GMC Jimmy
"T"

I brought mine out close to the hedlight and popped it out through one of the slats in the grill opening right behind my HELLA 500.

Is it easy to remove the block heater? I need to replace it with a 220V50hz one. Yes I know the 50hz is pointless.

_________________
No longer a CRD or Jeep owner. Selling everything I have, needs to go as I need the room for a project.