LOST JEEPS :: View topic - block heater location

I went out tonight to plug in my 01 Dodge with cummins and thought about the Jeep. I can not find the heater plug. Where are they hiding it. I got the manual out and it was no help. it said it was on the left side of the engine then in parentheses said on 3.7 L only. I know it says it is not required until it gets to 0 F. But the instant heat would be nice, wouldn't have to warm Jeep for so long in the morning. Just want to know.
Thanks
T

Author:	tshikle [ Thu Jan 18, 2007 1:24 am ]
Post subject:	block heater location
I went out tonight to plug in my 01 Dodge with cummins and thought about the Jeep. I can not find the heater plug. Where are they hiding it. I got the manual out and it was no help. it said it was on the left side of the engine then in parentheses said on 3.7 L only. I know it says it is not required until it gets to 0 F. But the instant heat would be nice, wouldn't have to warm Jeep for so long in the morning. Just want to know. Thanks T

Author:	Pablo [ Thu Jan 18, 2007 2:04 am ]
Post subject:	Re: block heater location
tshikle wrote: I went out tonight to plug in my 01 Dodge with cummins and thought about the Jeep. I can not find the heater plug. Where are they hiding it. I got the manual out and it was no help. it said it was on the left side of the engine then in parentheses said on 3.7 L only. I know it says it is not required until it gets to 0 F. But the instant heat would be nice, wouldn't have to warm Jeep for so long in the morning. Just want to know. Thanks T Plug is wrapped around the dipstick. Follow the stick down and you will see it wire tied.

Author:	tshikle [ Thu Jan 18, 2007 2:29 pm ]
Post subject:
Pablo Thanks for the input. You were exactly right. It was there. I cut it loose and routed it towards the front of the Jeep. May have to reroute it, Still can not get to it without raising the hood Thanks again T

Author:	Kniggit [ Thu Jan 18, 2007 2:44 pm ]
Post subject:
Should be enough cord to run it out near the opening near the tow hooks, just barely, and it tucks right back up really nice, most people poke it though the grille too. K

Author:	tshikle [ Thu Jan 18, 2007 2:59 pm ]
Post subject:
Kniggit wrote: Should be enough cord to run it out near the opening near the tow hooks, just barely, and it tucks right back up really nice, most people poke it though the grille too. K Okay thanks I look at other options.

LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/

block heater location http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=16631	Page 1 of 1

Author:	action [ Fri Jan 19, 2007 3:43 pm ]
Post subject:
I brought mine out close to the hedlight and popped it out through one of the slats in the grill opening right behind my HELLA 500.

Author:	jinstall [ Mon Jan 22, 2007 10:27 am ]
Post subject:
Is it easy to remove the block heater? I need to replace it with a 220V50hz one. Yes I know the 50hz is pointless.

Page 1 of 1	All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/