It's most likely swarbar links and bushings. they are designed to wear and are usually covered by the basic warranty. they sound like the front end is falling off when worn.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Horrible sound from Front end http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=17094 |
Page 1 of 1 |
| Author: | lea ann [ Tue Jan 30, 2007 11:42 am ] |
| Post subject: | Horrible sound from Front end |
When going over speed bumps that dips down on the other side of it or through a hole whithout going soo slow, a horrible grinding nose comes from the front right side of the jeep. It sounds horrible and hubby said it was the rubber bushings rubbing. Hubby said not to worry but it has 45k miles on it and this is being added to our long list of problems. I am not traveling fast through these holes and speed bumps by anymeans. I do not rag out my jeep, we have waited too long to have a new car and we just so happened to be diesel freaks and just had to have the CRD. We are only covered under the 7/70 warranty now and we don't want to have to replace these if we don't have to. Is anyone else having this problem with this noise? |
|
| Author: | midwest [ Tue Jan 30, 2007 12:59 pm ] |
| Post subject: | |
I get a similar noise going over speed "tables" but I don't recall if it is from the front or rear of the Jeep. I think your hubby is on to something regarding the bushings-particularly in the cold. Remember that even going slow over speed bumps will cause a large amount of travel in the suspension. |
|
| Author: | GregScuba [ Tue Jan 30, 2007 1:05 pm ] |
| Post subject: | |
It could be one of the engine mounts, have someone rock the jeep violently back and forth by the roof rails while you are underneath with a flash light (engine skid plate removed). Look at the relation of the engine/top of the engine mount, and the frame/bottom of the mount. If you can hear a clunk, and watch the mount clunk over side to side as if it is sloppy/loose, then you have a loose motor mount bolt or a bad mount. It seems there is problems with the engine mount(s) failing, especially the passenger side, with some of our CRD's. Hopefully your clunk is nothing though. If it turns out to be bushings, you could lubricate them with silicone grease. |
|
| Author: | dodgeramvan [ Tue Jan 30, 2007 1:57 pm ] |
| Post subject: | |
It's most likely swarbar links and bushings. they are designed to wear and are usually covered by the basic warranty. they sound like the front end is falling off when worn.
|
|
| Author: | Marlon_JBT [ Tue Jan 30, 2007 2:40 pm ] |
| Post subject: | |
Sway Bar Bushings. Been there and done that on 3 different KJs. We don't even worry about it anymore because it can only be temporarily fixed. Just chalk it up to it being a Jeep. They make lots of strange noises. |
|
| Author: | FastTRX [ Tue Jan 30, 2007 9:35 pm ] |
| Post subject: | |
Check out the 4X4 forum....we have the same noises coming from the petrol KJs...it's not just a "CRD-Related" noise. It's definitly the front sway bar bushings. Like Marlon said...it's a Jeep thing. I used NAPA brand Silicone Spray....spray ALOT in the bushings and where the swaybar connects to the Lower A-Arm...it should take care of the noise for a while until they dry out again. I've shot mine twice this month....it's a temporary fix. Happy Jeeping... |
|
| Author: | GregScuba [ Wed Jan 31, 2007 1:20 am ] |
| Post subject: | |
Wouldn't aftermarket polyurethane bushings solve this problem? |
|
| Author: | lea ann [ Wed Jan 31, 2007 1:36 am ] |
| Post subject: | |
Thanks for the quick replies! I read them to Mike and he said, "I told you so!!" When I called the dealership today, I decided not to say anything about them. We will se what the dealership does about all the "CRD's troubles" before we do anything about the bushings. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|