My wife as brought the CRD in a garage and they did not found any error code.
So they say that she have to comme back with the light on !
But the problem is that the light stay on for only short period.
| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| 4 lo light on?? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=20125 |
Page 1 of 1 |
| Author: | Mykol [ Wed Apr 25, 2007 9:48 pm ] |
| Post subject: | 4 lo light on?? |
I recently experienced a wierd thing when driving at low speeds on local city stretts. A couple of times at very light throttle and a steady speed around 20mph, I began to lose power and the "4 lo mode" light came on. I would let off the go pedal and the idle was smooth. Eased back in to the throttle; had full power and light went off. I didn't get the codes read, but have an appointment at the dealer Monday. Any ideas?? |
|
| Author: | alphred [ Tue May 29, 2012 12:03 pm ] |
| Post subject: | Re: 4 lo light on?? |
bump ! Have the same trouble !!! Can some one help ? Thanks |
|
| Author: | alphred [ Tue May 29, 2012 12:23 pm ] |
| Post subject: | Re: 4 lo light on?? |
My wife as brought the CRD in a garage and they did not found any error code. So they say that she have to comme back with the light on ! But the problem is that the light stay on for only short period.
|
|
| Author: | alphred [ Tue May 29, 2012 7:56 pm ] |
| Post subject: | Re: 4 lo light on?? |
update. The mecanic find a stored code 0012. I found: 12= batterie or computer recently disconected... It make almost 3 weeks that i have clean the battry post.... does it mean something four you ? thanks |
|
| Author: | alphred [ Mon Jul 02, 2012 8:24 pm ] |
| Post subject: | Re: 4 lo light on?? |
Still have this probleme occasionally. Can some help me ? |
|
| Author: | CATCRD [ Mon Jul 02, 2012 9:45 pm ] |
| Post subject: | Re: 4 lo light on?? |
I would inspect the wire bundles in your engine bay for damaged wires. 4 lo mode should not be associated with low power. |
|
| Author: | naturist [ Mon Jul 02, 2012 11:20 pm ] |
| Post subject: | Re: 4 lo light on?? |
The US version of the Libby CRD was supplied with only one transmission/transfer case combination, as far as I know. I know nothing about what our Canadian brothers (and sisters) were supplied. I do know that the gas versions for the US had several such. My CRD has a transfer case shifter that has 2 WD, 4WD (part time), 4WD (full time), neutral, and finally 4WD Lo on it, and the indicator lights are on the display below the tachometer. The sensor that causes the lights to display is in the transfer case and is supposed to sense the position of the shifter, and it sometimes goes bad, reporting a position that is not true. If you get "4 Lo" light displayed, and you haven't moved the shifter out of either 2 WD or 4 WD (full time), whichever you normally drive around in, the sensor has failed and needs to be replaced. This is not an expensive repair, and it should be noted that just because the sensor reports a bogus transfer case situation does not mean that anything else is wrong; the transfer case actual position is entirely controlled by that shifter, not by the light/sensor. |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|