clday25 wrote:
So I just finally got around to installing my SEGR pre-built kit that I’ve been sitting on for over a year. However, I’m now getting a cell, P0103 that comes on a couple minutes/seconds after I start driving….. Actually the check engine light flashes on for a moment after start up then turns off… then kicks back on after I start driving. The code is always P0103. If i clear it, much like when I was ORM'ing it stays off tell the next start-up.
From my understanding, this is a MAF related cell. So I pulled the MAF last night, cleaned it with MAF safe cleaner and reinstalled it, making sure to the connection was secure. Again the cell came on, which I cleared and then called it a night. This morning, the cell came on as I backed out my driveway and put it into drive…….
I’m stumped. Is my MAF bad? Is there something wrong with my SEGR kit/wiring?
Any help would be greatly appreciated!
Chris
Well possibly, ill check the code out out and see what I can find, i can say that the only time I cleaned my MAF sensor with maf safe cleaner it blew it up....... my rule now is if it hasnt got mud on it its fine.
Are you sure about the code (P0103)
_________________
KJ CRD 2.8L AUTO 2007
BP ULTIMATE
Extra Transmission cooler
2.5 inch full flow muffler.
Fuel Heater Disconnected.
In tank lift pump
Provent
Boost, EGT and Trans temp.
Engine Bay Vents soon.
Transgo Valve body (no resistor)
Hemi TC P04736587AC replaced (original TC P04736582AD in '07 KJ CRD) - Nice -:)
If im not here Im there....