| LOST JEEPS http://www.lostjeeps.com/forum/phpBB3/ |
|
| Where is the Plug for the Engine Block Heater? http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=25103 |
Page 1 of 1 |
| Author: | fatweasel [ Sat Oct 06, 2007 6:08 am ] |
| Post subject: | Where is the Plug for the Engine Block Heater? |
Can't find it in the manual - haven't crawled under yet. Just want to know the general vicinity (drivers side/passenger side/front right etc). Thanks |
|
| Author: | Jeger [ Sat Oct 06, 2007 6:55 am ] |
| Post subject: | |
drivers side...its bundled up with a reusable tie. You should be able to get it from the topside. Everyone says theirs was attached to the dipstick tube...mine was not. |
|
| Author: | gmctd [ Sat Oct 06, 2007 10:05 am ] |
| Post subject: | |
Remove the vanity cover to reveal the dipstick tube with attached ac power cord |
|
| Author: | brew1 [ Tue Oct 09, 2007 12:00 am ] |
| Post subject: | |
Ya, my 2005 CRD came in from Arizona and it still had the heater plug zip tied to the dipstick. Guess they didn't have much use for block heaters in Arizona. |
|
| Author: | 0311_DoC [ Tue Oct 09, 2007 12:18 am ] |
| Post subject: | |
is it visible once you remove the cover? or do you have to reach down and grab it? how long is it? |
|
| Author: | Joe Romas [ Tue Oct 09, 2007 6:43 am ] |
| Post subject: | |
0311_DoC wrote: is it visible once you remove the cover? or do you have to reach down and grab it? how long is it?
As mentioned above it's coiled up and attatched to the dip stick tube  Find the engine oil dip stick and look down 2 inches  Now I guess it's possible that it's not there as in removed or rerouted but that's where they were originally put 
|
|
| Author: | dgeist [ Tue Oct 09, 2007 9:06 am ] |
| Post subject: | |
0311_DoC wrote: is it visible once you remove the cover? or do you have to reach down and grab it? how long is it?
Once you un-wrap it, it's a couple feet long, just about enough to snake through and around the fuse panel and up to the driver's side headlamp and out through the grille. I tie-wrapped mine in place in a couple places to keep it away from excess heat during operation and left the tail (w/rubber plug) rest in the little chamber behind the headlamp. Reachable when you need it and out of the way the rest of the time. Dan |
|
| Author: | skywarn [ Tue Oct 09, 2007 9:28 am ] |
| Post subject: | |
it is poss that you may not have one... I do not have one, and its not listed on my build sheet either 
|
|
| Author: | Sir Sam [ Tue Oct 09, 2007 2:39 pm ] |
| Post subject: | |
skywarn wrote: it is poss that you may not have one... I do not have one, and its not listed on my build sheet either
really? interesting...... |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|