LOST JEEPS
http://www.lostjeeps.com/forum/phpBB3/

CRD Lift results -- How High can you go
http://www.lostjeeps.com/forum/phpBB3/viewtopic.php?f=5&t=27612		 Page 1 of 1
Author:  bugnout [ Mon Dec 17, 2007 2:03 pm ]
Post subject:  CRD Lift results -- How High can you go
I was following the discussion of JeepinAl's 4" lift and was wondering what kind of lifts and what amount of lift everyone was getting. It would be good for comparison purposes to have unlifted KJ's report as well.

How to measure:
Measure from the bottom of the flare at the edge to the center of the wheel. Measurement should be straight down. you can use a plumb bob or a nut on a string. I used a pencil at the wheel center as a reference then use a tape measure. Might want to empty all the tools and cargo out before you measure, and park on the flat. Report your results in the following format:

2005 CRD Sport, lift installed Oct 2006
Front Lift kit: Daystar 2" lift pucks and RRO .125 strut spacer,
Front Right: 19 7/8
Front Left: 19 7/8
Rear Lift kt: Daystar 2" puck and stock spring isolator
Rear Right: 20 1/4
Rear Left: 20 1/4
Issues: None so far
Author:  bugnout [ Fri Dec 21, 2007 5:19 pm ]
Post subject: 
bump, Anyone with a Frankenlift or Rusty's care to post thier measurements?
Author:  Turbo Tim [ Fri Dec 21, 2007 6:26 pm ]
Post subject: 
I went with the Franklin Lift, OME struts and springs, stayed with the stock upper A arms, and I got exactly 3" front and back (from before and after, using the same tires, etc.).

I am still waiting for it to settle some, but so far I am extremely pleased with the ride. I would do it again in a second...
Author:  bugnout [ Fri Dec 21, 2007 7:46 pm ]
Post subject: 
Turbo Tim wrote:
I went with the Franklin Lift, OME struts and springs, stayed with the stock upper A arms, and I got exactly 3" front and back (from before and after, using the same tires, etc.).

I am still waiting for it to settle some, but so far I am extremely pleased with the ride. I would do it again in a second...


I'm considering the same, but would really like to know how much taller it is. Do you have time to provide measurements?
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/